Jenn-Air JER8750 9Surface Cooking, Coil Element Surface, Surface Indicator Lights, Panel Light

Page 10
9Surface Cooking

9Surface Cooking

Surface Indicator Lights

This light is on when the corresponding surface _

elemensurfacetelementis o . Theisturnedligh woffill. turn off when the _

(glass-ceramiccooking surface models only)

Hot Surface Lights

Each element has a hot surface _ indicator light. A light will be ___,.___

illuminated

when

the

/

 

-"_,,,_"_

matching

 

surface

/

 

uG_°rro_cng_op"_'_

element

is

hot.

II

_

 

/"

///_v

will remain

on,

even

_

 

S/

after the control is turned off,

_

_

until the area has cooled.

They are

_

located at the front center of the cooktop,

To lift cooktop: When cool, grasp the front edge of the

ofcoothektocooktp.Gentlyop snaplift upintountilplacethe. two support rods at the front

U

[ I

'L[ _ SUPPORTROD

V

To lower cooktop: Hold the front edge of the cooktop and

carefully push back on each support rod to release. Then gently lower the top into place. The support rods will slide

into the range frame.

Panel Light

Coil Elements

The panel light is turned on by pushing the rocker switch on the backguard and hold-

ing it until the light comes on. It may be

turned off by pushing the other side of the Panel switch.

Coil Element Surface

Lift-up Porcelain Cooktop

To prevent the cooktop from discoloring or staining: (select models)

Clean cooktop after each use.

Wipe acid or sugar spills as soon as the cooktop has cooled as these spills may discolor or etch the

porcelain,

Your range features an upswept porcelain cooktop that can be lifted up for convenient access to the area under the cooktop.

When an element is turned on, it will cycle on and off to maintain the heat setting.

Coil elements are self-cleaning.

Do not immerse in water.

To remove: When cool, raise element. Carefully pull out

and away from receptacle.

To replace: Insert terminals on the element into receptacle. Guide the element into place. Gently press down on the outer edge of the element until it sits level on the drip bowl.

TERMINALS
Image 10
Contents For Future For Future Assistance In Case of FireGeneral SafetyInstructions InstructionsChild Safety Important Safety InstructionsSelf-Cleaning Oven Important Safety Notice and Warningat a Glance Rangeglass-ceramiccooktop Function Pads CleanControls at a Glance BroilCancel Clock Display Option Setting the ClockSetting the Timer Control OptionsSetting Clock Controlled Oven Cooking Beeps Timer Beep OptionsOven Temperature Adjustment Option Clock Controlled Oven Cooking Beep OptionsSurface Cooking Setting the ControlsSuggested Heat Settings Surface ControlsCoil Element Surface Surface Indicator Lights9Surface Cooking Hot Surface LightsDrip Bowls SurfaceCooking Cooking AreasOven Setting the Controls forOven Operation LightRack Positions Oven VentRACK2 Half Rack select modelsBROIL Baking ChartSetting the Controls for Broiling Oven OperationClock Controlled Oven Cooking Setting the ControlsOven Operation Setting the Controls for a Self-CleanCycle Care and CleaningSelf-CleanOven Before Self-CleaningTo Delay the Start of a Clean Cycle Care and Cleaning /6TO Cancel Self-Clean After Self-CleaningWhen cool, wash with soapy water, rinse and dry Oven Interior Care and Cleaning /8Cooktop Oven RacksMaintenance 9 MaintenanceCleaning Products Oven DoorStorage Drawer MaintenancePanel Light Oven LightBefore You Call For Service Before You Call for Service Oven will not self-cleanWhat is Not Covered By These Warranties WarrantymmmJENN-AIR