Jenn-Air JER8550 Oven Vent, RACK2, Rack Positions, Half Rack select models, Oven Operation

Page 13
Oven Vent

Oven Operation ]2

¢.

Oven Vent

When the oven is in use, never block the vent opening,

on glass-ceramic range

OVENon coilelementrangeVENT LOCATION

On a coil element surface, be sure the drip bowl in the vent location has a hole in the

RACK2:

Used for roasting small cuts of meat, casseroles, baking loaves of bread, bundt cakes or custard pies.

RACK 1:

pies, dessert souffles or angel food cake.

Multiple Rack Cooking:

Used for roasting large cuts of meat and poultry, frozen Two rack: Use rack positions 2 and 4, or 1 and 4.

center. Do not cover the drip bowl with

aluminum foil.

Oven Racks

Half Rack (select models)

Tab.,

OVENoPENINGVENTTo install in oven:

Support A£_

_

a. Always install half rack

,L ,_

 

when oven is cool.

Q_Q'-_

 

2.To install, grasp top center of thehalfrack. Align the side arm support between the top fourth

_'-,Q'--Q _ ._'_ Front

Your oven has two racks. They are designed with a lock-

stop edge.

To remove: Pull rack straight

"_=\

©_

stop position; lift up on the front of the rack and pull out.

out until it stops at the lock- _ rack support in the oven; tilt

the front end up slightly; slide rack back until it clears the

lock-stop position; lower front and slide back into the oven.

Donotcoveranentirerackwithaluminumfoilorplacefoil

on the oven bottom. Baking results will be affected and

damage may occur to the oven bottom, To replace: Place rack on the

and fifth oven rack guides. Insert the two tabs on the back frame of the half rack into the slots on the upper left rear

of the oven wall.

3.Push firmly on the top surface of the half rack until the tabs

on the fourth oven rack guide.

4.Check for proper installation b placing your hand on the

slide into the slots and the half rack side arm support rests and pressing down firmly.

To remove from the oven:

When the oven is cool, grasp the

 

 

top center of the half rack and

 

 

pull upward until the back tabs

 

 

on the rack slide out of the oven

. [(.......//

.

top surface of the half rack

back slots.

 

 

Rack Positions

RACK 5 (highest

 

position):

 

Used for toasting

4

bread or broiling

3

thin non-fatty foods.

2

RACK 4:

1

Used for most

 

broiling.

 

RACK 3:

Used for most baked goods on a cookie sheet or jelly roll pan, layer cakes, fruit pies, or frozen convenience foods.

Image 13
Contents For Future In Case of Fire For Future AssistanceInstructions SafetyGeneral InstructionsSelf-Cleaning Oven Important Safety InstructionsChild Safety Important Safety Notice and Warningat a Glance Rangeglass-ceramiccooktop Controls at a Glance CleanFunction Pads BroilSetting the Timer Setting the ClockCancel Clock Display Option Control OptionsOven Temperature Adjustment Option Timer Beep OptionsSetting Clock Controlled Oven Cooking Beeps Clock Controlled Oven Cooking Beep OptionsSuggested Heat Settings Setting the ControlsSurface Cooking Surface Controls9Surface Cooking Surface Indicator LightsCoil Element Surface Hot Surface LightsCooking SurfaceDrip Bowls Cooking AreasOven Operation Setting the Controls forOven LightRACK2 Oven VentRack Positions Half Rack select modelsSetting the Controls for Broiling Baking ChartBROIL Oven OperationClock Controlled Oven Cooking Setting the ControlsOven Operation Self-CleanOven Care and CleaningSetting the Controls for a Self-CleanCycle Before Self-CleaningTO Cancel Self-Clean Care and Cleaning /6To Delay the Start of a Clean Cycle After Self-CleaningWhen cool, wash with soapy water, rinse and dry Cooktop Care and Cleaning /8Oven Interior Oven RacksCleaning Products 9 MaintenanceMaintenance Oven DoorPanel Light MaintenanceStorage Drawer Oven LightBefore You Call For Service Oven will not self-clean Before You Call for ServiceWhat is Not Covered By These Warranties WarrantymmmJENN-AIR