library (fast search). If the device you want to control responds to the remote, press CHAN- to switch over to slow search. By pressing CHAN- several times you will be able to step backwards through the library. As soon as your device responds again press ENTER to complete the setup.
7.6.Identifying codes found using the search procedure
1.Press and hold the SETUP until the LED lights steadily. Release the SETUP button.
2.Press the mode button that matches the equipment you want to identify TV, VCR, etc.). The LED blinks once.
3.Press and release SETUP. The LED blinks once.
4.To find the first digit press each number button from 0 to 9 until the LED blinks. The number you pressed is the first digit of the code
5.Press each number button from 0 to 9 again as above to find the second digit.
6.Press each number in turn to find the third digit. When the third digit has been found, the LED goes out.
8.Troubleshooting
Poor quality of all TV channels
1.Obstructions of the signal can sometimes affect the transmission quality. Move the CableLink 75 transmitter or receiver a few centimetres to solve the problem.
2.Change the channel settings (A .. D) at both the transmitter as the receiver. The channel setting on the transmitter must match the setting on the receiver (e.g. both set to B)
Poor quality of some of the TV channels
1.Check the antenna connection of the CableLink 75 transmitter. You can check the signal at the transmitter side by connecting a TV to the antenna connection directly. It is especially important to check your antenna system if high frequency channels contain more noise that lower frequency channels.
2.If the found TV channel is not tuned exact enough, use the FINE TUNE + and FINE TUNE – buttons to fine tune the TV channel. Press CBL ADD/DEL to store the new settings.
The infrared extender does not work
1.Is the infrared extension cable connected to the CabeLink 75 transmitter? Are the infrared eyes attached to your equipment at the right position? Try to experiment with their location if you are not convinced of the right position on your device.
2.If you use a wireless headphone, wireless speakers or other equipment using 433,92 MHz transmission, this could affect the range of the infrared extender function dramatically. Switch of these devices to improve the range.
The remote won’t control you’re A/V equipment or doesn’t work at all
1.Use manual controls or the original remote to confirm the equipment is working properly
2.Be sure you pressed the device key for the device you want to control
3.
CABLELINK | 13 |