Jenn-Air W10253462A Electrical Requirements Canada Only, Countertop Preparation

Page 8

If connecting to a 3-wire system:

Local codes may permit the use of a UL listed, 3-wire, 250-volt, 40- or 50-amp range power supply cord (pigtail). This cord contains 3 copper conductors with ring terminals or open-end spade terminals with upturned ends, terminating in a NEMA Type 10-50P plug on the supply end. Connectors on the appliance end must be provided at the point the power supply cord enters the appliance. This uses a 3-wire receptacle of NEMA Type 10-50R.

3-wire receptacle (10-50R)

Electrical Requirements - Canada Only

WARNING

Electrical Shock Hazard

Electrically ground range.

Failure to do so can result in death, fire, or electrical shock.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate and wire gauge are in accordance with local codes.

Be sure that the electrical connection and wire size are adequate and in conformance with CSA Standard C22.1, Canadian Electrical Code, Part 1 - latest edition, and all local codes and ordinances.

A copy of the above code standards can be obtained from:

Canadian Standards Association

178 Rexdale Blvd.

Toronto, ON M9W 1R3 CANADA

Check with a qualified electrical installer if you are not sure the range is properly grounded.

Range Rating*

 

Rating of

Circuit

 

 

Power

Protection

 

 

Supply Cord

 

 

 

 

 

120/240 Volts

120/208 Volts

Amps

Amps

 

 

 

 

8.8 - 16.5 KW

7.8 - 12.5 KW

40

40 or 50

16.6 - 22.5 KW

12.6 - 18.5 KW

50

50

 

 

 

 

 

 

 

*The NEC calculated load is less than the total connected load listed on the model/serial rating plate.

A time-delay fuse or circuit breaker is recommended.

This range is equipped with a CSA International Certified Power Cord intended to be plugged into a standard 14-50R wall receptacle. Be sure the wall receptacle is within reach of range’s final location.

Do not use an extension cord.

Countertop Preparation

(for Slide-in Ranges Only)

The cooktop sides of the slide-in range fit over the cutout edge of your countertop.

If you have a square finish (flat) countertop and the opening width is 30" (76.2 cm), no countertop preparation is required.

Formed front-edged countertops must have molded edge shaved flat ³⁄₈" (1.0 cm) from each front corner of opening.

Tile countertops may need trim cut back ³⁄₈" (1.0 cm) from each front corner and/or rounded edge flattened.

30"

(76.2 cm)³⁄₈"

(1.0 cm)

30 ¾"

(78.1 cm)

If countertop opening width is greater than 30" (76.2 cm), adjust the ³⁄₈" (1.0 cm) dimension.

Countertop must be level. Place level on countertop, first side to side, then front to back. If countertop is not level, range will not be level. Range must be level for satisfactory baking conditions.

8

Image 8
Contents Table of Contents/Table des matières Range Safety Your safety and the safety of others are very importantLocation Requirements Installation RequirementsTools and Parts Product Dimensions Cabinet Dimensions Venting Requirements Venting MethodsWall Venting Floor VentingConcrete Slab Installations Exhaust Through Wall Concrete Slab Installations Exhaust Through Window WellCalculating Vent System Length Left or Right Side VentingIf connecting to a 4-wire system Electrical Requirements U.S.A. OnlyExample vent system Electrical ConnectionCountertop Preparation If connecting to a 3-wire systemElectrical Requirements Canada Only Installation Instructions Adjust Leveling LegsInstall Anti-Tip Bracket Unpack RangeRear Wall Venting Install Downdraft SystemDetermine Equivalent Length of Vent System Go to the Electrical Connection section View from Motor Side of Blower Wood spacers Mounting bracket Blower Power Supply Cord Direct WireStyle 1 Power supply cord strain relief Electrical Connection U.S.A. OnlyStyle 2 Direct wire strain relief Wire connection Power Supply Cord Wire Connection Direct Wire Bare Wire Torque Specifications Wire Awg TorqueConnect Range to Downdraft System Wall Venting Top View Floor Venting Side Venting left side venting shownComplete Installation If you need Assistance or ServiceFor power supply cord-connected ranges Moving the RangeFor direct-wired ranges Sécurité DE LA Cuisinière Votre sécurité et celle des autres est très importanteOutils et pièces Exigences D’INSTALLATIONExigences d’emplacement Dimensions du placard Dimensions du produitInstallations dans les régions au climat froid Exigences concernant l’évacuationPour obtenir des performances optimales Air d’appointInstallations sur dalle de béton Évacuation par le mur Méthodes d’évacuationÉvacuation par le plancher Évacuation par la gauche ou par la droiteCalcul de la longueur effective du circuit d’évacuation Exemple de circuit d’évacuationComposant Conduit de diamètre de 15,2 cm Longueur maximum = 60 pi 18,3 mSpécifications électriques Préparation du plan de travailRéglage des pieds de nivellement Instructions D’INSTALLATIONDéballage de la cuisinière Déterminer la longueur équivalente du circuit d’évacuation Installation de la bride antibasculementInstallation du circuit d’évacuation Par le bas Évacuation par le mur arrière Vue de dessus22,8 cm Vue du ventilateur côté moteur Placer 2 cales en bois et les fixer au sol Évacuation par le mur Vue de dessus Évacuation par le plancher Vue de dessusAchever l’installation Si vous avez besoin d’assistance ou de serviceCuisinières alimentées par cordon d’alimentation Déplacement de la cuisinièrePour les cuisinières avec câblage direct Page W10253462A 2009 All rights reserved

W10253462A specifications

The Jenn-Air W10253462A is a highly regarded appliance in the realm of kitchen innovation. This sophisticated range is known for its blend of style, versatility, and cutting-edge technology, making it an essential addition for both cooking enthusiasts and professional chefs alike.

One of the main features of the W10253462A is its powerful induction cooking capabilities. Induction cooking utilizes electromagnetic energy to heat pots and pans directly, resulting in faster cooking times and improved energy efficiency. This technology not only reduces cooking time but also provides precise temperature control, allowing for a seamless cooking experience. Additionally, the smooth surface of the induction cooktop makes it easy to clean, as spills can be wiped away without difficulty.

Another standout characteristic of the W10253462A is its oven performance. This model typically includes a convection oven which circulates hot air for even cooking results. The convection feature ensures that meals are cooked evenly, reducing the chances of hot spots and undercooked areas. Furthermore, with multiple cooking modes, users can roast, bake, or broil with ease, providing versatility for various recipes.

The appliance often includes advanced safety features as well. For example, the induction cooktop generally comes with automatic shut-off functionality, which turns off the burners if no cookware is detected, ensuring peace of mind when cooking. Additionally, child lock settings are available, making this range a safe option for families.

In terms of aesthetics, the Jenn-Air W10253462A typically boasts a sleek, modern design that complements any kitchen decor. The stainless steel finish not only enhances its visual appeal but also contributes to its durability and resistance to smudges and fingerprints.

Moreover, the appliance often incorporates smart technology, allowing users to control their cooking settings remotely through a smartphone app. This innovation not only increases convenience but also enables users to monitor their dishes' progress from anywhere in the house.

The Jenn-Air W10253462A is truly a blend of sophisticated design and advanced technology, suitable for anyone looking to enhance their cooking experience. With its induction cooking, advanced oven features, safety mechanisms, and smart capabilities, this appliance stands out as a top choice for modern kitchens.