Before You Make the Electrical Connection:
To properly install your cooktop, you must determine the type of electrical connection you will be using and follow the instructions provided for it here.
■A
■The cooktop should be connected directly to the junction box through the flexible metal conduit. The flexible, armored cable extending from the fuse box or circuit breaker box should be connected directly to the junction box.
■Locate the junction box to allow as much slack as possible between the junction box and the cooktop so that the cooktop can be moved if servicing becomes necessary in the future.
■A UL listed or CSA approved conduit connector must be provided at each end of the power supply cable (at the cooktop and at the junction box).
■If the house has aluminum wiring follow the procedure below:
1.Connect a section of solid copper wire to the pigtail leads.
2.Connect the aluminum wiring to the added section of copper wire using special connectors and/or tools designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices.
INSTALLATION INSTRUCTIONS
Prepare Cooktop
Decide on the final location for the cooktop.
WARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop. Failure to do so can result in back or other injury.
1.Open product as instructed on product packaging.
2.Remove shipping materials and tape from cooktop.
3.Remove vent grille.
A
C
B
D
A. Vent grille
B. Filter support tray
C. Removable grease filter
D. Ceramic glass top
4.Remove the removable grease filter by lifting the filter out.
5.Using 2 or more people, remove the cooktop from the carton.
6.Use foam end caps from the packaging as a work surface for the floor or countertop.
7.Using 2 or more people, place the cooktop upside down on the foam end caps.
8.Make sure knobs are positioned in the open areas of the end caps.
9.Avoid placing the cooktop facedown on the control knobs.
Install Foam Strip
1.Remove foam strip from the package containing literature.
2.Remove backing from foam strip.
3.Apply foam strip
NOTE: The foam strip keeps the underside of the cooktop glass free from debris and helps the cooktop sit flat on uneven counters.
A
B
C
A. Cooktop base
B. Foam strip
C. Glass
Rotate Blower - Optional
IMPORTANT: The following additional steps must be performed if the product is being installed in peninsula or island cabinetry.
The blower exhaust scroll is shipped from the factory set to exhaust straight out the back of the cabinet through an exterior wall.
D
E
C | E |
AB
F
A.Blower exhaust scroll
B.Plenum
C.Blower motor
D.Top label
E.
8