Burner Input Requirements
Input ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m).
For elevations above 2,000 ft (609.6 m), ratings should be reduced at a rate of 4% for each 1,000 ft (304.8 m) above sea level (not applicable for Canada).
Gas Supply Pressure Testing
Gas supply pressure for testing regulator must be at least
1" water column pressure above the manifold pressure shown on the model/serial rating plate.
Line pressure testing above ½ psi gauge (14" WCP)
The cooktop and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of ½ psi (3.5 kPa).
Line pressure testing at ½ psi gauge (14" WCP) or lower
The cooktop must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psi (3.5 kPa).
INSTALLATION INSTRUCTIONS
Install Cooktop
Decide on the final location for the cooktop.
WARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop. Failure to do so can result in back or other injury.
1.Open carton as instructed on product packaging.
2.Remove shipping materials and tape from cooktop.
3.Remove the removable grease filter by lifting the filter out.
4.For island or peninsula installations, go to the “Rotate Blower - Optional” section.
A
A. Removable grease filter
5.Using 2 or more people, remove the cooktop from the carton.
REMEMBER: An undercounter
6.Place cooktop right side up into the cutout.
NOTE: Make sure that the front edge of the cooktop is parallel to the front edge of the countertop. If repositioning is needed, lift entire cooktop up from the cutout to avoid scratching the countertop.
7.Connect blower exhaust scroll to ducting.
8.Use vent clamps to secure the ducting to the blower exhaust scroll.
9.Reinstall grease filter.
10.Reinstall vent grille.
Rotate Blower - Optional
IMPORTANT: The following additional steps must be performed if the product is being installed in peninsula or island cabinetry.
The blower exhaust scroll is shipped from the factory set to exhaust straight out the back of the cabinet through an exterior wall.
D
E
C | E |
A | B |
F |
|
A. Blower exhaust scroll | D. Top label |
B. Plenum | E. |
C. Blower motor | F. Motor mounting plate |
To rotate blower:
1.Locate the 4 plastic plugs in the plenum bypass.
2.Use the pliers to remove the plastic plugs.
IMPORTANT: Do not throw away the plastic plugs. The plastic plugs must be reinstalled after the blower exhaust scroll has been rotated.
A | E |
| |
B |
|
C | D |
| |
A. Blower motor | D. Blower bypass |
B. Exhaust scroll | E. Plastic plugs (4) |
C. Plenum |
|
9