Jenn-Air W10418362B installation instructions Connect to Water Supply, Connect to Drain

Page 19

Place level against top front opening of tub. Check that dishwasher is level from side-to-side. If dishwasher is not level, adjust front legs up or down until dishwasher is level.

Connect to Water Supply

Be sure rubber washer is properly seated in fitting. Slide the ³⁄₄" fitting up to the valve and hand tighten to avoid cross- threading. Hand tighten until the coupling is tight.

Using pliers, check the tightness of the coupling. An additional ¹⁄₄ to ¹⁄₂ turn may be required to seal the rubber gasket.

NOTE: Do not overtighten. Damage to the coupling can result.

Place paper towel under 90° elbow fitting. Turn on water supply and check for leaks. If leak occurs, repeat previous step.

If needed, see website for animated representation of this step. Visit www.jenn-air.com/watersupplyunder FAQ tab.

NOTE: Do not use Teflon®† tape with compression fittings.

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

Connect to Drain

Place towel under drain hose to catch any water in drain hose. Place the small drain hose clamp onto the small end of the drain hose. Push the new drain hose into the black drain hose connector up to the drain hose stop.

Using pliers, squeeze open the small drain hose clamp and slide onto connector between stops.

After hose is connected, remove towel.

If needed, see website for animated representation of this step. Visit www.jenn-air.com/drainunder FAQ tab.

19

Image 19
Contents Installation Instructions Undercounter Dishwasher Table of Contents Addition, for first-time installations All InstallationsTools and Parts Call 1-800-688-1100 to order Location RequirementsPage Water Supply Requirements If connecting dishwasher with a power supply cordIf connecting dishwasher with direct wiring Drain RequirementsPrepare Cabinet Opening-New Utilities Prepare Cabinet Opening-Existing UtilitiesPrepare and Route Water Line Option B, Direct WireInstall Drain Hose Option B, No waste disposer no air gap Option A, Waste disposer no air gapOption C, Waste disposer with air gap Prepare Dishwasher Install Moisture Barrier Under a wood countertopOption D, No waste disposer with air gap Option A, Remove Access Panel Plastic Make Power Supply Cord ConnectionOption B, Remove Access Panel Metal Panel Page Determine Cabinet Opening Choose Attachment Option Install Door Handle on some modelsOption A, Countertop attachment Option B, Dishwasher side attachment Prepare Water Supply LineMove Dishwasher Close to Cabinet Opening Page Connect to Drain Connect to Water SupplyMake Direct Wire Electrical Connection Secure Dishwasher in Cabinet Opening Bottom Sound Pad Installation On some models Complete Installation Additional Tips Reconnect PowerCheck Operation If Dishwasher Does Not OperateIl faut Table DES MatièresOutillage et pièces Exigences DinstallationExigences demplacement Page Pour le raccordement direct du lave-vaisselle Exigences d’évacuationSpécifications de l’alimentation en eau Spécifications électriquesOption A, cordon d’alimentation Préparation de louvertureDencastrement du placard Moyens de Raccordement pré-existantsOption B, raccordement direct Préparation et acheminement de la Canalisation d’eauInstallation du tuyau d’évacuation Option B pas de broyeur à déchets sans brise-siphon Option a broyeur à déchets sans brise-siphonOption C broyeur à déchets avec brise-siphon Option D pas de broyeur à déchets avec brise-siphon Préparation du lave-vaisselleOption a Retrait du panneau daccès Panneau en plastique Raccordement du cordon dalimentationOption B Retrait du panneau daccès Panneau métallique Avertissement Évaluation de l’ouverture dencastrement du placard Choix de l’option de fixation Installation de la poignée de porte Sur certains modèlesOption A, Fixation au plan de travail Option B, Fixation au côté du lave-vaisselle Préparation de la canalisation Dalimentation en eauAvertissement Remarques Raccordement au circuit dévacuation Raccordement à l’alimentation en eauRaccordement électrique direct Page Remarques Option B Installation du panneau daccès Panneau métallique Achever linstallationRétablir la source de courant électrique Si le lave-vaisselle ne fonctionne pas Contrôle du fonctionnementConseils supplémentaires