Move Dishwasher Close to Cabinet Opening
WARNING
Excessive Weight Hazard
Use two or more people to move and install dishwasher.
Failure to do so can result in back or other injury.
Using 2 or more people, stand dishwasher. upright. NOTE: Do not install kick plate until instructed to do so.
IMPORTANT:
NOTE: Do not push on the front of the panel or on the console. Panel or console may dent.
Helpful Tip: Temporarily tape utilities to the floor in the locations shown to prohibit them from moving when dishwasher is moved into the cabinet opening.
Check that water line is on the left side of opening and drain hose is near the center of the cabinet opening.
With another person holding the dishwasher to keep it from tipping, open and close the door a few times. If the door closes or falls open under its own weight, the door tension will need to be adjusted.
To adjust the door spring tension, unhook the spring from the rear leg of dishwasher.
Using a ⁵⁄₁₆" nut driver or hex socket, remove the screw from the tensioner.
The screw can be put into one of three holes (1, 2, 3) in the front leg of dishwasher. If the door closes by itself, move the tensioner to a higher number hole and replace the screw. Reattach door spring to rear leg.
NOTE: Tensioners on both sides of dishwasher should be secured at same holes.
17