Jenn-Air JDB-5 warranty Lights/Display, Delay

CYCLES, OPTIONS AND LIGHTS

Lights/Display

Delay

The Delay option can be used to automatically start the cycle at a later time to reduce daytime heat buildup in the home or to take advantage of reduced energy costs if available in your area. This option is also useful for conserving hot water at times of high household usage (showers, laundry).

To set up a Delay:

1.Select the appropriate cycle and options for the load. Close the door.

2.Press the Delay pad or button until the desired amount of delay time is selected.

3.The Delay indicator and the count down display (select models) will flash until the START/Cancel pad or START button is pressed.

4.As soon as the START/Cancel pad or START button is pressed, the flashing will stop and the delay time will begin counting down. The Delay indicator will remain lit until the delay time has counted down.

5.The cycle will automatically start as soon as the delay time expires.

Note

•If 30 seconds elapse between setting the cycle and options and pressing the START/Cancel pad or START button, the dishwasher will turn off.

To cancel a Delay:

When the delay is counting down, press the Delay pad or button again. The indicator light will go out and the cycle will start or resume immediately.

To cancel a Delay and the cycle: (All touchpad control models)

•Press START/Cancel once to drain and turn off the dishwasher.

Or

•Press START/Cancel twice to turn dishwasher off without draining.

To cancel a Delay and the cycle: (Cycle selector knob models)

•Turn the cycle knob to Drain/OFF. The dishwasher will drain, then turn off.

Or

•Turn the cycle knob to Drain/OFF, press the START button once. The dishwasher will turn off without draining.

Cont.

12