Bloomfield 8752 owner manual Servicing Instructions, Temperature Adjustment

SERVICING INSTRUCTIONS (continued)

TEMPERATURE ADJUSTMENT

Unplug power cord or turn circuit breaker OFF. Remove top panel.

Pull vent tube out of tank lid and insert a thermometer of known accuracy in hole. Reconnect brewer to electrical power.

Place empty container under brew chamber. Energize brewer and allow unit to heat. When READY TO BREW light glows, read the temperature displayed on thermometer.

Adjust WATER TEMP by turning shaft of thermostat; clockwise increases temperature. Refer to Table 1 below for proper brewing temperature based on altitude.

Upon completion, remove thermometer and reinstall the plug.

CAUTION:

SHOCK HAZARD

These procedures involve exposed electrical circuits. These procedures are to be performed by qualified technical personnel only.

NOTE:

Optimum brewing temperature range is 195ºF to 205ºF (90ºC to 96ºC).

IMPORTANT:

Amechanical thermostat will maintain temperature within ±5ºF. To prevent boiling water in the brewer, thermostat should be adjusted to a maximum temperature equal to the local boiling temperature minus 5ºF.

Fig. 10 Checking and Adjusting Brew Temperature

(ºF)	210
	205
TEMP.
	200
	195
	190
					0	,500 ,000		2,500	,000				4,000				00		000			00			00 ,500
	0	500		,0							,500					4,5				5,5				6,0
				1	1		2		3	3								5,							6
				0
				ELEVATION (feet above seal level)
(ºC)	100
	97
TEMP.	94
	91
	88
	0	1	0	3		450	600	0	0	.0		0	.2		0	.350		.5		.6				.800 .950
								75	90
		5		00							5			0				1	00	1	50		1
										1			1		1										1
				ELEVATION (meters above seal level)

BOILING

POINT OF WATER

IDEAL BREWING TEMPERATURE

MAXIMUM TEMPERATURE SETTING

BOILING

POINT OF WATER

IDEAL BREWING TEMPERATURE RANGE

MAXIMUM TEMPERATURE SETTING

605 70988 Owners Manual Integrity 5W Decanter Brewer

Table 1 Boiling Temperature by Altitude

12