OPERATION
Fig. 4 Brewer Operation Diagram
IMPORTANT:
Tank must be full of water before pressing TANK HEATER SWITCH "ON". Heating elements will be damaged if allowed to operate without being fully submerged in water. Damage caused by operating the brewer without water in the tank is NOT COVERED BY WARRANTY.
START-UP
For initial
♦Be sure spray disk and brew gasket are properly installed in the brew head.
♦Be sure the water supply is properly connected and the water supply valve is turned ON.
♦Be sure the WATER TANK IS FILLED
BEFORE connecting brewer to electrical power THE WATER TANK MUST BE FILLED. Place an empty decanter under the brew head. Lift the
Once the tank is full of water, connect the brewer to electrical power. Press the TANK HEATER SWITCH to “ON”. The heating elements will begin heating the water in the tank. When the water has reached the proper temperature, the READY TO BREW light will glow.
605 70988 Owners Manual Integrity 5W Decanter Brewer
6