What to do if...
Remedying small malfunctions
If one of the following fault codes is displayed in the
–Fault codeÅ 10 (Problems with water inlet),
–Fault codeÅ 20 (Problems with water drainage), please have a look at the following table.
When the fault is remedied, press the button for the cycle that has started. The cycle will continue.
With other fault codes (“Å ” followed by a number):
–Abort the dishwashing cycle.
–Switch the appliance off and on again.
–
If the fault is displayed again, please contact your local Service Force Centre and inform them of the fault code.
Malfunction | Possible cause | Remedy | |
| Water tap is blocked with | Check the water tap and | |
| limescale or faulty. | have it repaired if necessary. | |
| The tap is turned off. | Turn the tap on. | |
The cycle indicator for the | The filter (where present) in | Clean the filter in the | |
the threaded hose fitting | threaded hose fitting. | ||
selected dishwashing cycle | on the tap is blocked. | ||
| |||
is flashing: |
| Cancel the dishwashing cy- | |
fault code Å 10 is dis- |
| ||
| cle (see chapter: Starting a | ||
played in the | Filters in the base of the | ||
dishwashing cycle), | |||
play: | |||
dishwasher compartment | clean filters (see chapter: | ||
(Problems with water in- | |||
are blocked. | Cleaning the filters), | ||
let) | |||
| then start the dishwashing | ||
|
| ||
|
| cycle again. | |
| Water inlet hose | Check the position of the | |
| has not been correctly posi- | ||
| tioned. | hose. | |
|
| ||
The cycle indicator for the | The sink spigot connection | Clean the sink spigot outlet. | |
selected dishwashing cycle | is blocked. | ||
| |||
is flashing, |
|
| |
fault code Å 20 is dis- | Water drain hose |
| |
played in the | Check the position of the | ||
play. | has not been correctly posi- | ||
(Problems with water | tioned. | hose. | |
| |||
drainage) |
|
| |
|
|
|
28