AEG 40730 manual What to do if, Remedying small malfunctions

Page 25

What to do if...

Remedying small malfunctions

If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault.

After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the button for the dishwashing cycle that had already started. The cycle will continue. In the case of other fault messages:

Cancel the dishwashing cycle.

Switch the appliance off and on again.

Select dishwashing cycle.

If the fault is displayed again, please contact the Customer Care De- partment and inform them of the fault message.

Malfunction

Possible cause

Remedy

 

The tap is blocked or furred

Clean tap.

 

with lime-scale.

 

 

 

 

 

 

The tap is turned off.

Turn the tap on.

The programme indicator for

The filter (where present) in

Clean the filter in the

the threaded hose fitting on

the selected dishwashing cy-

the tap is blocked.

threaded hose fitting.

cle is flashing,

 

 

 

the indicator for the end of

 

Cancel the dishwashing

the dishwashing cycle is

 

cycle (see chapter:

flashing in rhythm 1 short

Filters in the base of the

Starting a dishwashing

light signal with approx. 3

cycle),

washing compartment are

second pause in-between:

clean filters (see chap-

blocked.

(Problems with water inlet)

ter: Cleaning the filters),

 

 

 

then start the dishwash-

 

 

ing cycle again.

 

Water inflow hose has not

Check hose installation.

 

been correctly positioned.

 

 

The programme indicator for

The sink outlet is blocked.

Clean out sink outlet.

the selected dishwashing cy-

 

 

cle is flashing,

 

 

the indicator for the end of

Water drain hose has not

 

the dishwashing cycle is

Check hose installation.

flashing in rhythm 2 short

been correctly positioned.

 

light signals one after anoth-

 

 

er.

 

 

 

 

 

25

Image 25
Contents Favorit Dear customer Following symbols are used in the textContents Prior to using for the first time SafetyChild safety General safetyControl panel Diagram of applianceFunction button Setting the water softener Prior to using for the first timeSetting manually Setting electronicallySetting Adding special salt Only when using the dishwasher for the first timeFilling up with rinse aid Setting the amount of rinse aid required Loading cutlery and dishes Daily usePots, Pans, Large Plates Loading cutleryCups, Glasses, Coffee Service Raising/lowering the upper basket Adjusting the height of the upper basketAdding detergent Concentrated detergents Using 3in1 detergentsDetergent tablets If you want to use 3in1 productsDishwashing Suitable Type Selecting the dishwashing cycle Cycle TableSelecting a programme Interrupting or aborting a dishwashing cycle Starting a dishwashing cycleAborting the dishwashing cycle Switching off the dishwasher Setting the Delay TimerRemoving the dishes Cleaning the filters Care and cleaningUpper basket spray arm Cleaning the spray arm jetsBottom spray arm Remedying small malfunctions What to do ifIndicator for the end Dishwashing cycle is Dishes are still dirty If the dishwashing results are not satisfactoryDishes do not dry and are not shining There are dried water drops on the glasses and dishesPackaging material DisposalOld appliance Technical data Full load Half load Example loading arrangementsPage Safety information for the installation Installation and connection instructionsInstalling the dishwasher Free-standing appliances Connecting to the water supply Connecting the dishwasherConnecting the inlet hose Permitted water pressureDrain hose Water drainageExtension hoses Sink outlet connectionElectrical connection Anti-flood systemConnecting systems Autres agences étrangères assurant le service après-vente Further after-sales service agencies overseasWeitere Kundendienststellen im Ausland Otros puntos de Postventa en el extranjeroE. Abu Dhabi Jordan Malta Hungary Page Service AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG