AEG 40730 manual Setting

3 If indicators for the programme buttons are lit, a dishwashing cycle is activated. The cycle must be deactivated:

Press function buttons 2 and 3 simultaneously for approx. 2 seconds. All additional wash programme button indicators will go out.

2.Press function buttons 2 and 3 simultaneously and keep them pressed. The LED indicators for function buttons 1 to 3 will flash.

3.Press function button 1.

The LED indicator for function button 1 will flash.

The LED indicator for the end of the dishwashing cycle will flash simul- taneously:

–The number of times that the LED indicator for the end of the dish- washing cycle flashes corresponds to the hardness setting.

–This sequence of flashes is repeated several times, with a 3 second pause in-between.

4.Pressing function button 1 increases the hardness setting by 1 degree. (Exception: hardness setting 1 follows hardness setting 10).

5.When the hardness setting is correct, press the ON/OFF button. The hardness setting is now saved.

If the water softener is set electronically to “1”, this switches off the control indicator for special salt.

	Water hardness			Adjusting the hardness
					setting		Number of
in °d1)		in mmol/l2)	Range	Manual		Electronic	flashes
51 - 70		9,0 - 12,5				103)	10
43 - 50		7,6 - 8,9				9	9
37 - 42		6,5 - 7,5	IV	1		8	8
29 - 36		5,1 - 6,4				7	7
23 - 28		4,0 - 5,0				6	6
19 - 22		3,3 - 3,9	III			5	5
15 - 18		2,6 - 3,2				4*	4
11 - 14		1,9 - 2,5	II	0*		3	3
4 - 10		0,7 - 1,8	I/II			2	2
below 4		below 0.7	I			1	1
						no salt
						necessary

1)(°d) German degree, measure of the hardness of water

2)[mmol/l] millimol per litre, international unit for water hardness

3)On this setting the length of the dishwashing cycle may be slightly longer. *) factory setting

8