Water drainage into sink (only possible with
If you wish to hang the drain hose in a wash basin, use a detachable hose elbow. You can obtain this from customer service by referring to spare part number ET 646 069 190.
1.Fit the elbow to the drain hose.
2.Secure the drain hose so that it cannot slide off the edge of the wash basin.
Pass a piece of cord through the hose elbow and fix it to the wall or the tap.
Anti-flood system
For protection from water damage, the dishwasher is equipped with a
In the event of a fault, the safety valve in the water inlet hose immedi- ately interrupts the supply of water to the appliance and the drain pump is activated. In this way water can neither escape nor overflow. The remaining water in the appliance is automatically pumped out.
Electrical connection
Details about the voltage, type of supply and the fuses required are to be found on the rating plate. The rating plate is located on the right- hand inner edge of the dishwasher door.
To isolate the dishwasher from the mains, pull out the mains plug.
Important:
–The plug must be accessible after the appliance has been installed.
–Following installation, live parts and insulated wiring must not be ac- cessible to a test finger in accordance with DIN EN
37