AEG 40730 manual Installation and connection instructions, Safety information for the installation

Page 32

Installation and connection instructions

1Safety information for the installation

•Only transport the dishwasher in an upright position, otherwise salt water may run out.

•Before using the dishwasher for the first time, check for any damage caused in transport. Do not under any circumstances connect an ap- pliance that is damaged. In the case of damage, please contact your supplier.

•Never use the dishwasher if the mains cable, water inlet or drain hose are damaged; or if the control panel, work top or plinth area are damaged such that the inside of the appliance is freely accessible.

•Always plug the mains plug into a correctly installed shockproof socket.

•Permanent connection: a permanent connection must only be in- stalled by a trained electrician.

•Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the sup- ply where the appliance is to be installed. The fuse rating is also to be found on the rating plate.

•Multi-way plugs / connectors and extension cables must not be used. This could constitute a fire hazard through overheating.

•The dishwasher’s cable must only be replaced by the Customer Care Department or a registered electrician.

•A water inlet hose with safety valve must only be replaced by the Customer Care Department.

32

Image 32

Contents Favorit Following symbols are used in the text Dear customerContents Safety Prior to using for the first timeChild safety General safetyDiagram of appliance Control panelFunction button Prior to using for the first time Setting the water softenerSetting manually Setting electronicallySetting Only when using the dishwasher for the first time Adding special saltFilling up with rinse aid Setting the amount of rinse aid required Daily use Loading cutlery and dishesLoading cutlery Pots, Pans, Large PlatesCups, Glasses, Coffee Service Adjusting the height of the upper basket Raising/lowering the upper basketAdding detergent Using 3in1 detergents Concentrated detergentsDetergent tablets If you want to use 3in1 productsSelecting the dishwashing cycle Cycle Table Dishwashing Suitable TypeSelecting a programme Aborting the dishwashing cycle Starting a dishwashing cycleInterrupting or aborting a dishwashing cycle Removing the dishes Setting the Delay TimerSwitching off the dishwasher Care and cleaning Cleaning the filtersCleaning the spray arm jets Upper basket spray armBottom spray arm What to do if Remedying small malfunctionsIndicator for the end Dishwashing cycle is If the dishwashing results are not satisfactory Dishes are still dirtyDishes do not dry and are not shining There are dried water drops on the glasses and dishesOld appliance DisposalPackaging material Technical data Example loading arrangements Full load Half loadPage Installation and connection instructions Safety information for the installationInstalling the dishwasher Free-standing appliances Connecting the dishwasher Connecting to the water supplyConnecting the inlet hose Permitted water pressureWater drainage Drain hoseExtension hoses Sink outlet connectionAnti-flood system Electrical connectionConnecting systems Further after-sales service agencies overseas Autres agences étrangères assurant le service après-venteWeitere Kundendienststellen im Ausland Otros puntos de Postventa en el extranjeroE. Abu Dhabi Jordan Malta Hungary Page Service AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG