HOT WATER CONNECTION
THESE INSTALLATION
INSTRUCTIONS ARE
INTENDEDFORUSEBY
QUALIFIEDINSTALLERS
Connecting the Hot Water
Supply Line
•If using a solder joint instead of a com- pression fitting, be sure to make all solder connections before connecting the water line to the dishwasher.
•Make sure there are no sharp bends or kinks in the water line which might restrict water flow.
•When connecting threaded pipe use pipe thread compound or Teflon tape to seal the connection.
•Before connecting the copper hot water supply line to the dishwasher, it should be flushed with hot water to clear any foreign material.
•Apply Teflon tape or other pipe sealant to 90° elbow fitting and connect directly to water inlet valve*.
•Turn on the water supply to check for leaks after making connections.
Shut off valve |
(not included) |
Figure 15
CAUTION
DO NOT SOLDER WITHIN 6 INCHES (152.4 MM) OF THE DISHWASHER’S INLET VALVE.
TEMPERATURES REQUIRED FOR SOLDERING WILL DAMAGE THE VALVE!
*Water inlet valve located at the bottom left front of the dishwasher.
Openings for water lines must be installed in the marked areas as shown in Figures 8 and 9 to avoid interference with the dishwasher frame or other components.
Figure 16
10 - ENGLISH www.boschappliances.com