Door Panel Installation

Accessory Panel Installation SHU Models

If you have an SHU model (other than the SHU 9910, 9920 or 9940 models) and have ordered an accessory panel kit it must be installed prior to sliding the dishwasher into place. Dimensions of panel size that may be used is shown in Figure 19.

Panel Installation, SHV Models

If you have an SHV model, a fully integrated model, you will have additional mounting hardware and a folded template sheet with installation instructions comprised of pictograms.

Refer to the folded template sheet for information on how to mount the panel. Please note that one side of the template shows how to mount a one piece panel and the other side of the template shows how to mount a two piece panel. Be sure of what type installation you want before proceeding with the installation.

Refer to Figure 20 and Table 3 for guidelines on custom door panel selections.

After deciding if the extension pieces will be used or not refer to the pictograms printed on the template for proper method of mounting your custom door.

Panel Installation, SHI Models

If you have an SHI model, an integrated model, you will have additional mounting hardware and a folded template sheet with installation instructions comprised of pictograms. In North America the black, white and stainless steel models of the integrated series (SHI series), have a control panel that is 5-5/16” (135 mm) tall. The black and white models come with a standard extension piece, dimension “A” in Figure 21 and Table 4, next page. The stainless steel model comes with two extension pieces, referred to as the standard and long extension piece in Table 4: the standard piece is used for drawer heights up to 6” (152mm); the long extension piece is used for drawer heights greater than 6” (152mm) but 6-7/16” (164mm) or less. These stainless steel extension pieces are not installed in the control panel. In the stainless steel models, the two extension pieces are shipped loose and must be inserted as shown in pictogram 5 on the template sheet.

The purpose of the extension piece is to allow the increase of the control panel height to try to match the horizontal drawer line of the cabinets. If your drawers are taller than the “C” dimension shown on Table 4, it is recommended that the extension either be slid in as far as it will go, or removed and the door made to fit directly below the control panel.

12 - ENGLISH www.boschappliances.com