Moffat MDB900 user manual Connecting to a hob or cooker point, Fitting into the cabinet

Page 35

Twist the bared wires using pliers.

Cut bared wires 10mm away from the end of the inner insulation. Where un-insulated Earth wires are used ensure they are suitably sheathed to leave 10mm bare wire to fit into the terminal.

Clamp bare wires into the relevant terminal and check they are held by tugging each one in turn.

Clamp the mains cable securely ensuring 5mm of the outer insulation is inside the terminal block and that the wires are not taught but not so slack as to cause any fouling.

Place fuse/miniature circuit breaker in circuit and switch on at mains.

Connecting to a hob or cooker point

Either follow in general terms the instructions for connecting to the terminal block or refer to the hob suppliers installation instructions.

WARNING!

Feed the cable through the cabinet and arrange to route the cable away from the appliance which may become hot.

Fitting into the cabinet

IMPORTANT!

Ensure that the oven is switched off at the wall before any further work is carried out.

Using a tape measure establish the internal width of the cabinet. Refer to recommended cabinet dimensions if greater than 565mm.

Position the appliance in front of the cabinet.

Checking electrical connections

Correct electrical connection can be confirmed when switching on the appliance, as the timer will be flashing.

IMPORTANT!

House circuit

Earth leakage and continuity tests must be carried out before the appliance is connected to the mains supply and re-checked after fitting.

Take out all oven furniture before installation to reduce the weight you need to lift. The oven door should be taped up to keep it closed whilst lifting.

To place the appliance into the cabinetry follow the procedure below:

35

Image 35
Contents Model Contents During use Important safety instructionsInstallation Child safetyCleaning and maintenance Product description Controls and their functions Electronic timerCookware Before using the applianceRating plate Condensation and steamGrill and oven furniture To set the countdown Electronic timerFirst switched on, Set the time of daySetting the oven timer control To cancel the countdownTo set the length Press the increase That the correct time of day is displayedCooking time. Press Control until Time indicator neon is Displayed IlluminatedButtons To stop the soundTo the time of day Things to note Using the dual grillGrill door must be left open when grilling Dual grillFood should be turned over during cooking as required Grill pan and handleHints and tips Food Grilling chartSelector to top oven Using the top ovenTop oven PreheatingTo fit the top oven shelf To turn off the top ovenBatch baking Cooking temperaturesUsing the main oven Main ovenTo turn the main oven off Pos Oven cooking chart= Shelf on the oven base Oven cooking chartMeat Temperature Cooking time Roasting chartOven fan and internal oven light will come on Using defrostDefrost Cleaning the control knobs and handles Care and cleaningCleaning materials Cleaning the outside of the applianceOuter door glass is removable for cleaning Cleaning the top oven roofCleaning the doors Ensure the screws are firmly in place after cleaningInner glass door is not removable To clean the inner glass door panelsCleaning the grill and oven furniture To replace the outer door glassType of bulb required is a 300C 25 watt small Edison Screw Replacing an oven light bulb Main ovenReplacing an oven light bulb Top oven Problem TroubleshootingTechnical details Energy save modeSwitching off the time display Switching on the time displayDo not lift the appliance by the handles House circuit Installation instructionsDo not alter the electrical circuitry of this appliance Choice of electrical connections Preparing cabinet for fitting of ovenRecommended cabinet dimensions mm This appliance must be earthed How to finish unpackingConnecting to the mains terminal To remove the mains terminal coverChecking electrical connections Connecting to a hob or cooker pointTwist the bared wires using pliers Fitting into the cabinetDo not remove spacers fitted behind fixing holes Do not attempt to lift this appliance by the handlesEach person should squat either side of the appliance Purchase date Service and spare partsCustomer care department 0870 5Exclusions Guarantee conditionsStandard guarantee conditions This guarantee does not coverEuropean guarantee Россия Page Page Page 311786600 05/2006 Subject to change without notice