AMX MVP-5200i Configuring Wireless Network Access, Configure the Device’s Wireless IP Settings

Configuring Communication

Configuring Wireless Network Access

The first step in connecting the MVP-5200i to a wireless network is to configure the wireless communication parameters within the device’s Wireless Settings page. This page only configures the card to communicate to a target WAP: the device must still be directed to communicate with the correct Master. This "pointing to a Master" is done via the System Settings page, which allows configuration of the IP Address, System Number and Username/Password information assigned to the target Master.

Step 1: Configure the Device’s Wireless IP Settings

The first step to a successful setup of the internal wireless card is to configure the IP Settings section on the Wireless Settings page. This section configures the communication parameters from the MVP panel to the web.

Wireless communication using a DHCP Address

In the Protected Setup page:

1.Select Wireless Settings. Wireless communication is set within the IP Settings section of this page (FIG. 19).

Wireless Access Point

Site Survey Button

FIG. 19 Wireless Settings page (IP Settings section)

2.Toggle the DHCP/Static field from the IP Settings section until the choice cycles to DHCP. This action causes all fields in the IP Settings section, other than Host Name, to be greyed-out.

DHCP will register the unique factory-assigned MAC Address on the panel, and once the communication setup process is complete, assign IP Address, Subnet Mask, and Gateway values from the DHCP Server.

3.Press the optional Host Name field to open the Host Name keyboard and enter the host name information.

4.Press Done after assigning the alpha-numeric string of the host name.

5.The remaining greyed-out fields in the IP Settings section cannot be altered. Once the panel is rebooted, these values are obtained by the unit and displayed in the DNS fields after power-up.

MVP-5200i Modero Viewpoint Widescreen Touch Panel 21