AMX MVP-5200i manual Static WEP Settings, WEP 64 / WEP

Protected Setup Pages

Static WEP Settings

Press the Static WEP button to open the Static WEP Settings page (FIG. 64).

FIG. 64 Wireless Settings page - Static WEP Settings

Static WEP security requires that both a target WAP be identified and an encryption method be implemented prior to establishing communication. In addition to providing both Open and Shared Authentication capabilities, this page also supports Hexadecimal and ASCII keys.

Static WEP Settings

SSID (Service Set Identifier):	Opens an on-screen keyboard to enter the SSID name used on the target
	WAP. The SSID is a unique name used by the WAP, and is assigned to all
	panels on that network. An SSID is required by the WAP before the panel is
	permitted to join the network.
	• The SSID is case sensitive and must not exceed 32 characters.
	• Make sure this setting is the same for all points in your wireless network.
	• NXA-WAP200Gs use AMX as their default SSID.
	• If this field is left blank, the panel will attempt to connect to the first available
	WAP.
WEP 64 / WEP 128:	Cycles through the available encryption options: 64 or 128 Bit Key Size.
	“WEP” (Wired Equivalent Privacy) is an 802.11 security protocol designed to
	provide wireless security equivalent to wired networks.
	• WEP64 enables WEP encryption using a 64 Bit Key Size. All packets are
	transmitted with their contents encrypted using the Default WEP Key.
	• WEP128 enables WEP encryption using a 128 Bit Key Size. All packets are
	transmitted with their contents encrypted using the Default WEP Key.
	• If the key is not the correct size, the system will resize it to match the
	number of bits required for the WEP encryption mode selected.

MVP-5200i Modero Viewpoint Widescreen Touch Panel 69