AMX MVP-5200i Miscellaneous MVP Strings back to the Master, MVP Panel Lock Passcode commands

Programming

"^" Button Commands (Cont.)

^UNI	For the ^UNI command (%UN and ^BMF command), the Unicode text is sent as
Set Unicode text.	ASCII-HEX nibbles.
	Syntax:
	"'^UNI-<vt addr range>,<button states range>,<unicode text>'"
	Variable:
	variable text address range = 1 - 4000.
	button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
	1 = Off state and 2 = On state).
	unicode text = Unicode HEX value.
	Example:
	SEND_COMMAND Panel,"'^UNI-500,1,0041'"
	Sets the button’s unicode character to ’A’.
	Note: To send the variable text ’A’ in unicode to all states of the variable text
	button 1, (for which the character code is 0041 Hex), send the following command:
	SEND_COMMAND TP,"'^UNI-1,0,0041'"
	Note: Unicode is always represented in a HEX value. TPD4 generates (through the Text
	Enter Box dialog) unicode HEX values. Refer to the TPDesign4 Instruction Manual for
	more information.

Miscellaneous MVP Strings back to the Master

The following two strings are sent by the MVP panel back to the communicating Master:

MVP Strings to Master

undock <master>	This is sent to the target Master when the MVP is undocked.
	• If the panel has no information within the User Access Passwords list, ’none’ is sent as
	a user.
	• If the undock button on the Protected Setup page is used, ’setup’ is sent as a user.
	• This string can be disabled from within the firmware setup pages.
dock	This is sent to the target Master when the MVP is docked.
	• This string can be disabled from within the firmware setup pages.

MVP Panel Lock Passcode commands

These commands are used to maintain a passcode list. With the MVOP-5200i, a password must be entered to remove the panel from the Wall Charging Station. Only the passcode is entered. The user entry is just for identifying the passcodes.

MVP Panel Lock Passcode Commands

^LPC

Clear all users from the User Access Passwords list on the Password Setup page.

Syntax:

"'^LPC'"

Example:

SEND_COMMAND Panel,"'^LPC'"

Clear all users from the User Access Password list on the Password Setup page. Refer to the Other Settings section on page 87 for more information.

132 MVP-5200i Modero Viewpoint Widescreen Touch Panel