AMX MVP-5200i manual Wireless Settings

Protected Setup Pages

Wireless Settings Page

Use the options on the Wireless Settings page (FIG. 61) to configure communication settings for the wireless CF card (802.11b/g), and read the device number assigned to the panel.

FIG. 61 Wireless Settings page (reads from and assigns values to the WAP)

Features on this page include:

Wireless Settings Page

Back:	Saves all changes and returns to the previous page.
Connection Status icon:	The icon in the upper-right corner of each Protected Setup page provides a
	constant visual indication of current connection status.
	Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
	Master.
IP Settings:	Sets the IP communication values for the panel:
DHCP/STATIC
	Sets the panel to either DHCP or Static communication modes.
	• DHCP - a temporary IP Addresses is assigned to the panel by a DHCP
	server. If DHCP is selected, the other IP Settings fields are disabled (see
	below).
	• Static IP is a permanent IP Address assigned to the panel. If Static IP is
	selected, the other IP Settings fields are enabled (see below).
IP Address
	Enter the secondary IP address for this panel.
Subnet Mask
	Enter the subnetwork address for this panel.
Gateway
	Enter the gateway address for this panel.
Host Name
	Enter the host name for this panel.
Primary DNS
	Enter the address of the primary DNS server used by this panel for host name
	lookups.
Secondary DNS
	Enter the secondary DNS address for this panel.
Domain
	Enter a unique name to the panel for DNS look-up.
MAC Address
	This unique address identifies the wireless Ethernet card in the panel (read-
	only).
Active Roaming on	When enabled, connection allows active roaming between WAPs by switching
Channels 1&11	between channels 1 and 11 if the other channel is unavailable.

64 MVP-5200i Modero Viewpoint Widescreen Touch Panel