AMX MVP-5200i manual MVP-WCS-52

Accessories

Screw holes

Plastic conduit box

Neodymium magnets

MVP-WCS-52

Rubber feet

FIG. 13 Installation of MVP-WCS-52

For ease of installation, put each screw on a neodymium magnet in the device’s interior compartment to keep them on hand until they are needed.

11.After fully seating the screws, wipe down the area around the screw holes with the alcohol prep pad from the Installation Kit. Take a rubber foot and remove its adhesive backing. Put the foot, adhesive- side down, in the slot surrounding the screw hole in the Wall Charging Station. Press down firmly to remove any air bubbles from underneath the foot.

12.Install an MVP-5200i device by placing it into the interior compartment bottom-first. Press the top of the touch panel until it is flush with the Wall Charging Station. The neodymium magnets will hold it in place.

13.To remove the MVP-5200i, unlock the touch panel (see the Unlocking the touch panel section on page 11 for more information) and wait for the touch panel to pull away from the Wall Charging Station. Once it has been released, grip it by the top of the device, and pull it free from the Charging Station.

MVP-5200i Modero Viewpoint Widescreen Touch Panel 15