Russell Hobbs RHDW1 instruction manual Electrical connection, Fitting the machine undercounter

Page 10

Electrical connection

The earthed plug of your machine should be connected to an earthed outlet supplied by suitable voltage and current. If there is no earthing installation, have a competent electrician carry out an earthing installation. In case of usage without earthing installed, our company will not be responsible for any loss of usage that might occur.

At low voltage, Wash efficiency of your machine decreases.

Always use the coated plug supplied with your machine.

The machine’s electrical cable should be replaced by an authorised service or an authorised electrician only. Failure to do so may lead to accidents.

For safety purposes, always make sure to disconnect the plug when a wash programme is finished.

In order not to cause an electric shock, do not unplug when your hands are wet.

When disconnecting your machine from the mains supply, always pull from the plug. Never pull the cord itself.

Fitting the machine undercounter

If you wish to fit your machine undercounter, check whether you have sufficient space under your countertop and whether the wiring-plumbing is suitable to do so. If you decide that the space under the countertop is suitable for fitting your machine, remove the worktop as shown in the illustration.

Warning:The stand part which will settle the machine under it by removing its worktop has to be stable in such a way not to allow balance disorder.

To remove the worktop, remove the screws that hold the worktop which are located at the rear of the machine; then push the front panel 1 cm from the front side towards the rear and lift it.

9

Image 10
Contents Dishwasher Contents Standard loading and Test data ………………………………………………………… Upper basket adjustable track latch Getting Familiar with Your Machine When you take delivery of your machine Safety Information and RecommendationsPoints to pay attention during machine installation Daily use For your children’s safetyCase of malfunctioning Items not suitable for dishwashing Installing the MachinePositioning the machine Water inlet hose Water connectionWater outlet hose Electrical connection Fitting the machine undercounterPage Preparing the Machine for USE Prior to using the machine for the first timeImportance of water decalcification Testing strip Adjusting salt consumption Filling the detergent compartment Points to consider when using this type of productsDetergent usage Combined detergentsWhen you give up using combined detergents Filling with rinse aid and making the settingLoading Your Dishwasher Dish rackLower Basket Folding Racks Top basket height adjustment while it is fullGoblet clamp Page Detergent / Rinse aid Standard loading and test data CapacityProgramme test Programme Descriptions Programme itemsProgram follow-up Switching on the Machine and Selecting a ProgrammeSwitching on the machine Changing a programmeChanging a programme with resetting Switching the machine offCleaning machine Maintenance and CleaningFilters Spray arms Hose filterIf the Wash/Dry and End lights keep flashing Failure Codes and What to do in Case of FailureIf the control light won’t go out after a wash operation If there are whitish stains on the dishes If the machine stops during a wash operationIf there are partial food wastes left on the dishes If the dishes wont dry upPractical and Useful Information 0845 683 8717 Opening times