If water is left inside the machine at the end of the programme
•The water drain hose is clogged or twisted.
•The filters are clogged.
•The programme is not finished yet.
If the machine stops during a wash operation
•Power failure.
•Water inlet failure.
•Program can be on standby mode.
If shaking and hitting noises are heard during a wash operation
•Dishes placed incorrectly.
•Spray arm hitting the dishes.
If there are partial food wastes left on the dishes
•Dishes placed incorrectly into the machine, sprayed water did not reach related places.
•Basket overly loaded.
•Dishes leaning against one another.
•Very small amount of detergent added.
•An unsuitable, rather weak wash programme selected.
•Spray arm clogged with food wastes.
•Filters clogged.
•Filters incorrectly fitted.
•Water drain pump clogged.
If there are whitish stains on the dishes
•A very small amount of detergent is being used.
•Rinse aid dosage setting at a very low level.
•No special salt is being used despite the high degree of water hardness.
•Water softener system setting is at a very low level.
•Salt compartment cap not closed well.
If the dishes won't dry up
•A programme without a dry operation selected.
•Rinse aid dosage set too low
•Dishes unloaded too fast.
If there are rust stains on the dishes
•
•High rate of salt in the wash water.
•Salt compartment cap not closed well.
•Too much salt spilt into the sides and into the machine while filling it with salt.
•Unhealthy mains grounding.
Call an authorised service if the problem still persists after the controls or in case of any malfunction not described above. Please see the back page at the ınstruction manual
26