Installation Instructions for Stacking
IMPORTANT
1.Disconnect or unplug all units from the wall socket before attempting to stack.
2.For stacking installation, you must use the PANASONIC Joining Plate which is enclosed with this unit.
INSTALLATION
3.The following PANASONIC models only are suitable for stacking:
4.The maximum stacking height is the total heights of two units.
PREPARATION
Be sure the oven cavity is empty.
1.Stack the units and remove five screws (a) as shown in Fig.1.
2.Loosen the screw (b).
3.Projection on Joining Plate must face away from the oven. Place Joining Plate on the screw (b).
4.Attach and tighten five screws (a) and the screw (b). See Fig.2.
5.Ensure the top oven is at a safe and workable height.
(b)
Joining Plate |
|
Projection | Joining Plate |
Projection
(a)
Fig. 1 | Fig. 2 |
|
Self Diagnostics Failure Code Explanation
This oven monitors its operation and displays a Failure Code in Digital Display Window when a problem occurs. What to do when a Failure Code appears: Disconnect the oven from the electricity supply and wait more than ten seconds before reconnecting. If normal operation does not resume, follow the next chart.
CODE | PROBLEM | WHAT TO DO |
|
|
|
F01 | Too high temperature of | The oven shuts off automatically. Disconnect the appliance from the electricity |
| exhausted air | supply. The oven beeps continuously and resets for operation when cool. Move |
|
| the oven to a cooler location. If the problem persists, call service agent. |
|
|
|
Defective thermistor circuit | The oven shuts off automatically. If the problem persists, call service agent. | |
|
|
|
F05 | Defective memory IC | If the problem persists, call service agent. The oven will operate even if Failure |
|
| Code appears, just not as designed. If the problem occurs during memory |
|
| heating, press Stop/Reset pad. Then other memory program and manual heating |
|
| will be possible. |
|
|
|
| Defective relay circuit | If the problem persists, call service agent. The oven will operate even if Failure |
|
| Code appears, just not as designed. Press Stop/Reset pad and try again. |
|
|
|
Defective relay circuit | The oven shuts off automatically. If the problem persists, call service agent. | |
|
|
|
F44 | Defective control panel | The oven shuts off automatically. If the problem persists, call service agent. |
|
|
|
Note: Above codes shown in Digital Display Window do not indicate all possible failures on the unit.
- 17 -