Middleby Marshall PS536ES installation manual

Page 2

WARNING

FOR YOUR SAFETY, DO NOT STORE OR USE

GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.

WARNING

Improper installation, adjustment, alteration, service, or maintenance can cause property damage, injury, or death. Read the installation, operation, and maintenance instructions thoroughly before installing or servicing this equipment.

NOTICE

The warranty is NOT VALID unless the oven is installed, started, and demonstrated under the supervision of a factory-authorized installer.

NOTICE

Contact your authorized Service Agency to perform maintenance and

repairs. A Service Agency Directory is supplied with your oven.

NOTICE

Using any parts other than genuine Middleby Marshall factory-manufactured parts relieves the manufacturer of all warranty and liability.

NOTICE

Middleby Marshall (Manufacturer) reserves the right to

change specifications at any time.

KEEP THIS MANUAL IN A VISIBLE LOCATION NEAR THE OVEN

FOR FUTURE REFERENCE.

ii

Image 2

Contents Owners operating Page Middleby Marshall IiiTable of Contents Section Description Model IdentificationDimensions PS536ES Series Oven SpecificationsSeries PS536ES Electrical Specifications General specifications per oven cavityII. Principle of AIR Flow Heat Transfer and How It WorksII. Principle of AIR Flow Air FingersPS536ES-Series Oven Components Locations III. Component Function FigureIII. Component Function Cooling Fan Blank Plates two sizes and an Air Finger F2. Blank PlatesSection Installation UnloadingPS536ES Oven Installation Required Kits and Equipment InstallationInstallation KIT see Figure Model PS536ES Single Oven Dimensions Model PS536ES Double Oven Dimensions Restraint Cable Installation Model PS536ES Triple Oven DimensionsInstallation II. Ventilation Guidelines IV. Electric Supply for Electrically Heated Ovens 11. Typical Electric Oven Data PlateVI. Conveyor Rear Stop and END Stop Installation 13. Installing Rear and End StopsSection Operation Control FunctionsII. Component Information and Location Figures 3-1 See Figures 3-4 Measuring Conveyor SpeedConveyor Shutdown Procedure Startup Procedures Daily StartupPower Failure III. STEP-BY-STEP OperationLocation and Description of Controls II. Normal Operation STEP-BY-STEP III. Quick Reference Digital Temperature Controller IV. Quick Reference Troubleshooting SymptomSection Maintenance Cooling Fan Maintenance DailyExterior Crumb Pans FigureII. Maintenance Monthly Section Maintenance Air Fingers Disassembly For Cleaning Standard FingersCleaning the Window Reassembly of Air FingersBack in the same way they came out Section Maintenance Reinstall End Plugs Conveyor Reassembly Into Oven Checking Conveyor Belt TensionConveyor Belt Link Removal Lower End Plug Replacing Conveyor BeltAttaching Drive Chain III. Maintenance Every 3 Months Cleaning the Blower/Fan MotorElectrical Terminals VentilationSplit-belt Conveyor Shaft Cleaning Section Maintenance IV. Maintenance Every 6 Months Important NoticesKEY Spare Parts KIT QTY DescriptionSection Troubleshooting Section Troubleshooting Parts List Parts List Oven PANELS, Window and Legs Parts List Control Panel Parts List Blower and Shroud Parts List Conveyor Item QTY Conveyor DescriptionParts List Split Belt Conveyor Element Machinery Compartment Section Parts List Electrical Electrical Section Schematics Electrical Schematics Section Wiring Diagram, G208-240V 50/60, GO PS536ES Section Electrical Schematics Section Electrical Schematics Page Hour Service Hotline