Maytag 1-82180-002 Freezer Care, Storage Gate, Cleaning Your Frost-Free Freezer, Base Grille

Page 6

Storage Gate

(on some models)

To Lower and Raise the Storage Gate:

1.Lift the top of the gate up slightly, out of the supports. Pull the gate forward and down.

2.Return the gate to the upright position. Lift the top of the gate slightly to clear the supports. Lower the gate into the supports.

FREEZER CARE

Cleaning Your Frost-Free Freezer

(some models)

WARNING

Explosion Hazard

Use nonflammable cleaner.

Failure to do so can result in death, explosion, or fire.

Frost-free means that you will never have to defrost your freezer. Frost is removed by air moving and collecting any moisture and depositing it on the cooling coil. The cooling coil periodically warms up just enough to melt the frost, and it then flows down to the drain pan (located behind the base grille) where it is evaporated.

Complete cleaning should be done at least once a year.

1.Unplug freezer or disconnect power.

2.Remove all frozen food. Wrap frozen food in several layers of newspaper and cover with a blanket. Food will stay frozen for several hours. You may also store frozen food in a cooler, additional refrigerator-freezer, or in a cool area.

3.Wash the inside walls with a solution of mild detergent in warm water or 2 tbs (26 mg) baking soda to 1 qt (0.95 L) warm water.

Do not use abrasive or harsh cleaners such as window sprays, scouring cleansers, flammable fluids, cleaning waxes, concentrated detergents, bleaches or cleansers containing petroleum products on plastic parts, interior and door liners or gaskets. Do not use paper towels, scouring pads, or other harsh cleaning tools. These can scratch or damage materials.

4.Rinse well and wipe dry with a clean soft cloth.

5.Use the appropriate cleaning method for your exterior finish.

Painted metal: Wash exteriors with a clean sponge or soft cloth and a mild detergent in warm water. Do not use abrasive or harsh cleaners, or cleaners designed for stainless steel. Dry thoroughly with a soft cloth. For additional protection against damage to painted metal exteriors, apply appliance wax (or auto paste wax) with a clean, soft cloth. Do not wax plastic parts.

Stainless steel finish: Wash with a clean sponge or soft cloth and a mild detergent in warm water. Do not use abrasive or harsh cleaners. Dry thoroughly with a soft cloth.

To keep your stainless steel refrigerator looking like new and to remove minor scuffs or marks, it is suggested that you use the manufacturer’s approved Stainless Steel Cleaner & Polish.

IMPORTANT: This cleaner is for stainless steel parts only!

Do not allow the Stainless Steel Cleaner & Polish to come into contact with any plastic parts such as the trim pieces, dispenser covers or door gaskets. If accidental contact does occur, clean plastic part with a sponge and mild detergent in warm water. Dry thoroughly with a soft cloth.

6.Replace all frozen food.

7.Plug in freezer or reconnect power.

8.See “Using the Control.”

Base Grille

To Remove and Replace the Base Grille:

1.Open the freezer door and remove the base grille by pulling down and out from the top.

2.Replace the base grille by putting the clips in the openings in the refrigerator panel. Push in until the base grille snaps into place.

Defrosting and Cleaning

Your Manual Defrost Freezer

( some models)

WARNING

Explosion Hazard

Use nonflammable cleaner.

Failure to do so can result in death, explosion, or fire.

Defrost and clean your freezer when frost has built up to about ¹⁄₄" (6 mm) thickness. Complete defrosting and cleaning should be done at least once a year. In high humidity areas, a freezer may need more frequent defrosting and cleaning.

6

Image 6
Contents Use & Care Guide Vertical FreezerCongélateur Vertical Guide d’utilisation et d’entretienTable of Contents Freezer SafetyInstallation Instructions UnpackingLocation Requirements Freezer USE Adjust the DoorUsing the Control Electrical RequirementsRefrigerated Shelves Freezer FeaturesKey Eject Lock Door BinFreezer Care Cleaning Your Frost-Free FreezerDefrosting and Cleaning Your Manual Defrost Freezer Storage GateStyle Power InterruptionsChanging the Light Bulb Style 1-Models with a drain systemThere is water in the defrost drain pan on some models TroubleshootingMoving Care Motor seems to run too muchAssistance or Service U.S.ACanada Freezer Warranty AccessoriesSécurité DU Congélateur Votre sécurité et celle des autres est très importanteDéballage Instructions DinstallationEmplacement d’installation Spécifications électriquesAjustement de porte Utilisation de la commandeUtilisation DU Congélateur AppropriéeCaractéristiques DU Congélateur Grille de la base Entretien DU CongélateurNettoyage du congélateur sans givre certains modèles Pour enlever et replacer la grille de la baseStyle 1-modèles avec système d’écoulement Style 2-modèles sans système d’écoulementPannes de courant électrique DéménagementLe plat de dégivrage contient de l’eau sur certains modèles DépannageLes ampoules n’éclairent pas Le moteur semble fonctionner excessivementAssistance OU Service AccessoiresGarantie DU Congélateur 82180-002 Rev