SERVICE (cont.)
LIMIT THERMOSTAT
P1161.40 |
FIG. 4 LIMIT THERMOSTAT |
Location:
The limit thermostat is located inside the rear of the hood on the tank lid.
Test Procedures:
1.Disconnect the brewer from the power source.
2.Disconnect the blue and black wires from the limit thermostat.
3.With an ohmmeter, check for continuity across the limit thermostat terminals.
If continuity is present as described, the limit thermo- stat is operating properly.
If continuity is not present as described, replace the limit thermostat.
Removal and Replacement:
1.Remove all wires from limit thermostat terminals.
2.Carefully slide the limit thermostat out from under the retaining clip and remove limit thermostat.
3.Carefully slide the new limit thermostat into the retaining clip.
4.Refer to Fig. 5 when reconnecting the wires.
BLU to BLU Lead from
Control Thermostat
BLK to Terminal Block or Tank Heater Switch
P1800
FIG. 5 LIMIT THERMOSTAT TERMINALS
Page 11 | 10860 | 061501 |
|
|