SERVICE (cont.)
TANK HEATER SWITCH (cont.)
13.Set tank assembly inside the hood on mounting brackets and secure with two
14.Reconnect the wires to the limit thermostat, tank heater and the control thermostat. Refer to Limit Thermostat, Tank Heater and Control Thermostat sections in this manual when reconnecting wires.
15.Secure the sprayhead tube to the hood using hex nut.
16.Install sprayhead.
17.Install fill basin, inlet gasket and secure to tank lid with tank inlet fitting.
18.Refer to Fig. 11 when reconnecting the wires.
Removal and Replacement: (VP17B)
1.Remove the tank inlet fitting securing fill basin to the tank lid. Remove fill basin and gasket. Set all three parts aside for reassembly.
2.Disconnect the two black wires from the tank heater switch.
3.Remove the plastic facenut, hex facenut and the switch indicator/guard bracket that secures tank heater switch to the brewer. Remove switch and discard.
4.Insert new tank heater switch through the hole in the lower left of the control panel and secure with swtich indicator/guard bracket, hex facenut and plastic facenut.
5.Reconnect the two black wires the to the tank heater switch terminals.
6.Install fill basin, inlet gasket and secure to tank lid with tank inlet fitting.
7.Refer to Fig. 11 when reconnecting the wires.
BLK to Limit
Thermostat
BLK to Terminal
Block (Black Insert)
P1135
FIG. 11 TANK HEATER SWITCH TERMINALS
Page 15 | 10860 | 090800 |
|
|