Bunn LCA-2 PC, LCC-2 manual Contents, BUNN-O-MATIC Commercial Product Warranty

Page 2

CONTENTS

Warranty

2

Programming the Dispenser Flow Rate

12

Introduction

3

Loading the Concentrate

18

User Notices

3

Priming the Concentrate Lines

18

Electrical Requirements

4

Operating the Pull & Hold Dispenser

19

Plumbing Requirements

5

Operating the Preset Portion Control Dispenser

20

Initial Set-up

5

Filling Cambros or other large containers

20

Electrical Hook-up

5

Cleaning & Preventive Maintenance

21

Plumbing Hook-up

5

Replacing the Pump Tubing

22

Setting Dispenser Flow Rate

6

Draining the Hot Water

23

Selecting the Correct Pump Tubing

7

Troubleshooting

24

Operating Controls & Interface

8

Field Calibration of the Concentrate Pumps

29

Initial Fill & Heat

9

Dispenser Flow Rate Calibration

30

FlavorGard™ Feature

10

Field Calibrating the Hot Water Flow Rate

30

Rinse Alarm Feature

10

Field Calibrating the Empty BIB Warning

31

BIB Empty Lockout Feature

11

Schematic Wiring Diagrams

32

Brew Temperature Lockout Feature

11

 

 

BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY

Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:

1)All equipment other than as specified below: 2 years parts and 1 year labor.

2)Electronic circuit and/or control boards: parts and labor for 3 years.

3)Compressors on refrigeration equipment: 5 years parts and 1 year labor.

4)Grinding burrs on coffee grinding equipment to grind coffee to meet original factory screen sieve analysis: parts and labor for 3 years or 30,000 pounds of coffee, whichever comes first.

These warranty periods run from the date of installation BUNN warrants that the equipment manufactured by it will be commercially free of defects in material and workmanship existing at the time of manufacture and appearing within the applicable warranty period. This warranty does not apply to any equipment, component or part that was not manufactured by BUNN or that, in BUNN’s judgment, has been affected by misuse, neglect, alteration, improper installation or operation, improper maintenance or repair, damage or casualty. This warranty is conditioned on the Buyer 1) giving BUNN prompt notice of any claim to be made under this warranty by telephone at (217) 529-6601 or by writing to Post Office Box 3227, Springfield, Illinois 62708-3227; 2) if requested by BUNN, shipping the defective equipment prepaid to an authorized BUNN service location; and 3) receiving prior authorization from BUNN that the defective equipment is under warranty.

THE FOREGOING WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ANY OTHER WARRANTY, WRITTEN OR ORAL, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF EITHER MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. The agents, dealers or employees of BUNN are not authorized to make modifications to this warranty or to make additional warranties that are binding on BUNN. Accordingly, statements by such individuals, whether oral or written, do not constitute warranties and should not be relied upon.

If BUNN determines in its sole discretion that the equipment does not conform to the warranty, BUNN, at its exclusive option while the equipment is under warranty, shall either 1) provide at no charge replacement parts and/or labor (during the applicable parts and labor warranty periods specified above) to repair the defective components, provided that this repair is done by a BUNN Authorized Service Representative; or 2) shall replace the equipment or refund the purchase price for the equipment.

THE BUYER’S REMEDY AGAINST BUNN FOR THE BREACH OF ANY OBLIGATION ARISING OUT OF THE SALE OF THIS EQUIPMENT, WHETHER DERIVED FROM WARRANTY OR OTHERWISE, SHALL BE LIMITED, AT BUNN’S SOLE OPTION AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND.

In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages.

34766 010407

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Post Office BOX SPRINGFIELD, Illinois Phone 217 529-6601 FAX 217Contents BUNN-O-MATIC Commercial Product Warranty00656.0000 IntroductionUser Notices 28181.0003Models with Master ON/OFF Switch Field Wiring Terminal Block DiagramModels without Master ON/OFF Switch Electrical RequirementsElectrical HOOK-UP Plumbing RequirementsInitial SET-UP Plumbing HOOK-UPReprogramming the Dispenser Flow Rate Setting Dispenser Flow RateRemoving the restrictors Rate Selecting the Correct Pump TubingDispense Oz/sec 16 I.D. TubingOperating Controls and Interface 1513Initial Fill & Heat Alarm Mode FlavorGard FeatureRinse Alarm Feature BIB Empty Lockout Feature Brew Temperature Lockout Feature351 + Programming the DispenserMenu Screen Action Description Tank Temp Exit 3/16Menu Screen Lock Flavor ? Exit YES Flavors Locked LF Disp VolumeRT Disp Volume 0oz +Ready Temp Menu Screen Tank TempExit + Cabinet TempBrew Lockout ? No Exit YES Menu ScreenRinse Lockout ? No Exit YES Action DescriptionCAL RT WTR Flow Pull Dispenser Menu Screen ActionCAL Right Pump ? Pull Dispenser CAL Right Side ? Exit YESTest LED’S ? No Exit YES Test Switches ? WTR Start DelayWTR Stop Delay Factory Defaults No YES Action DescriptionLoading the Concentrate Priming the Concentrate LinesOperating the Pull & Hold Dispenser Filling Cambros or other large containersOperating the Preset Portion Control Dispenser Models LCA-2 PC, LCA-2C PC, LCA-2A PCDaily Parts Washing Cleaning & Preventative MaintenanceGeneral Cleaning and Sanitizing Procedures Daily Rinsing Weekly SanitizingReplacing the Pump Tubing Draining the HOT Water Tank Front Panel LED Display Messages TroubleshootingPower LED OFF Concentrate BIB is Empty Internal FaultLeft Refill LED on Empty BIB WarningTubing kinked or blocked Check Tubing installation Troubleshooting Dispenser Diagnostics-LCD DisplayBIB Not properly connected Check BIB Connector Fittings Possible CauseScreen Displayed Possible Cause RPM Sensor failure Service Required Evaporator temperature too high Service RequiredMotor failure Service Required Cabinet circulating fan failure Service RequiredCalibrating the Left Side Dispenser Oz/sec 74 ml/sec w/o flow restrictor Field Calibrating the Hot Water Flow RateOz/sec 53 ml/sec w/ flow restrictor Calibrating the Right Side DispenserField Calibrating the Empty BIB Warning Calibrating The Empty BIB ThresholdLCA-2/LCA-2, PC/LCA-2C/LCA-2C, PC/LCC-2/LCC-2C Schematic Wiring Diagram Schematic Wiring Diagram LCC-2A/LCA-2A/LCA-2A, PC
Related manuals
Manual 36 pages 62.09 Kb Manual 26 pages 22.61 Kb

LCA-2 PC, LCA-2, LCC-2 specifications

The Bunn LCC-2, LCA-2 PC, and LCA-2A are high-performance commercial coffee brewers designed to meet the demands of busy coffee shops, restaurants, and other food service establishments. These machines are known for their efficiency, durability, and advanced brewing technologies, making them popular choices in the industry.

Starting with the Bunn LCC-2, this brewer is recognized for its compact design and ease of use. It has a brewing capacity of up to 3.8 gallons per hour, ensuring that coffee is ready quickly during peak hours. The LCC-2 uses a pour-over brewing method, which means that water is heated to the ideal brewing temperature and then poured over coffee grounds for optimal extraction. One of its standout features is the digital temperature control, which allows operators to adjust brewing temperatures easily for different coffee types. Additionally, the Bunn LCC-2 features a stainless steel construction that enhances durability and provides a sleek look for any commercial kitchen.

Moving on to the Bunn LCA-2 PC, this model includes programmable capabilities, making it perfect for establishments that require consistency and convenience. The LCA-2 PC allows users to preset brewing schedules and customize brew cycles, ensuring that each pot of coffee meets specific flavor profiles. This model is designed with a large-capacity brewing system that can produce up to 7.5 gallons of coffee per hour, making it an ideal choice for high-demand environments. It also boasts a built-in hot water faucet, which provides instant hot water for other beverages or culinary applications. The LCA-2 PC's advanced brewing automation helps maintain optimal brew quality while minimizing waste.

Lastly, the Bunn LCA-2A is an advanced version that focuses on automation and efficiency. This brewer features a state-of-the-art digital brew timer, which allows precise control over brew times, leading to consistent flavor extraction. The LCA-2A also integrates with Bunn’s patented brewWISE technology, which tracks brew recipes and monitors performance. The intuitive interface allows for easy operation, even for staff who may be less experienced with coffee brewing. With a capacity of up to 4 gallons per hour and a durable stainless steel frame, the LCA-2A ensures longevity while delivering exceptional coffee.

In summary, the Bunn LCC-2, LCA-2 PC, and LCA-2A represent the pinnacle of commercial coffee brewing technology. Their unique features, including programmable settings, large brewing capacities, and durable constructions, cater to the diverse needs of the food service industry. Each model emphasizes convenience, flexibility, and quality, making them invaluable assets in any professional coffee environment.
Top Page Image Contents