Bunn FCD-4 manual Service Lockout

Page 17

ADJUSTMENT & OPTIONAL SETTINGS (cont)

b)In a 5 second period, press and release the “Chilled Water Switch” the number of times that you want the password set to (maximum of 10.) For example: If you want the password set to 3, press and release the “Chilled Water Switch” 3 times in the 5 second period.

c)Release the “Hidden Switch”.

d)At the end of the 5 second period, the password will be confirmed by the “REFILL” indicators flashing the password.

3.Exit the “Pump Speed Programming” mode by simultaneously pressing both “Hidden Switches”. Note that the beeper sounds twice and that the “PROGRAM” indicator extinguishes.

4.To lockout the dispenser, proceed as follows:

a)Press and hold either “Hidden Switch”.

b)In a 5 second period, press and release the “Chilled Water Switch” the “password” number of times. For example: If the password is set to 3, press and release the “Chilled Water Switch” 3 times in the 5 second period.

c)Release the “Hidden Switch”.

d)At the end of the 5 second period, the dispenser will extinguish the merchandising lamp, and all dispense functions will be disabled.

5.To enable the dispenser, proceed as follows:

a)Press and hold either “Hidden Switch”.

b)In a 5 second period, press and release the “Chilled Water Switch” the “password” number of times. For example: If the password is set to 3, press and release the “Chilled Water Switch” 3 times in the 5 second period.

c)Release the “Hidden Switch”.

d)At the end of the 5 second period, the dispenser will light the merchandising lamp, and dispense functions will be enabled.

6.If the password is forgotten, it can be reset to “0” (dispenser lockout disabled) as follows:

Note: The following procedure also clears the programming and service lockout password.

a)Disconnect the dispenser from its power source.

b)Place the “Refrigeration Switch” Fig 3, in the OFF (reward) position.

c)While pressing and holding the “Chilled Water Switch”, connect the dispenser to its power source.

d)Continue to hold the “Chilled Water Switch” until the dispenser beeps three times, then release.

e)The passwords are now returned to “0” (no programming or service lockout password/dispenser lockout disabled.)

f)After 3 minutes, place the “Refrigeration Switch” in the ON (forward) position.

Service Lockout

Should a dispense station become inoperative and require service, the station’s dispense and rinse functions can be independently locked out, while keeping the remaining stations running.

1.To place a single dispense station in “Service Lockout,” open the dispenser door, press and hold either “Hidden Switch” and the desired dispense station “Product Dispense” (“+/Stop”) switch for 10 seconds.

2.At the end of the 10 second period, the beeper will sound a double tone and the dispense position will be disabled. Place the DISPENSE/RINSE Knob to “DISPINSE” and close the dispenser door.

3.To remove a dispense station from “Service Lockout,” open the dispenser door, press and hold either “Hidden Switch” and the desired dispense station “Product Dispense” (“+/Stop”) switch for 10 seconds.

4.At the end of the 10 second period, the beeper will sound a double tone and the dispense position will be enabled. Close the dispenser door.

17

33496 011101

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Phone 217 529-6601 FAX 217 Post Office BOX SPRINGFIELD, IllinoisWarranty ContentsCharge User NoticesElectrical HOOK-UP Initial SET-UPElectrical Requirements Plumbing Hookup Plumbing RequirementsSanitize Switch Refrigeration SwitchOperating Controls Water Bath and Main Water ValvesOperating Controls Frozen Concentrates Initial FillLoading Priming Initial Fill Ambient Concentrates OptionalPortion Control Models Refer to Fig Dispenser USEPress and Hold Models Refer to Fig Weekly Sanitizing Cleaning & Preventive MaintenanceDaily Parts Washing Cleaning Annually Replace Pump Tubing Cleaning Monthly Clean Condenser Air FilterSetting the MIX RATIO/BRIX Adjustment & Optional SettingsTemperature Compensated Refractometer Method Ratio Cup MethodPump Speed Programming Mix RatioProduct Brix % Chilled Water Flow Testing and Adjustment Adjustment & Optional SettingsCup Size Programming Portion Control Dispensers Only Dispenser LockoutService Lockout Adjustment & Optional Settings Password Protection Cooling Coolant Schematic Diagram Schematic Wiring Diagram

FCD-4 specifications

The Bunn FCD-4 is a commercial coffee dispenser designed to meet the demands of busy environments such as cafes, restaurants, and catering businesses. Known for its durability and performance, the FCD-4 has become a popular choice among coffee service operators.

One of the main features of the Bunn FCD-4 is its ability to hold and dispense up to four different flavors of coffee, allowing businesses to cater to diverse customer preferences. This multifunctionality is critical in settings where customers appreciate variety. With its 4.0-gallon capacity, the FCD-4 is engineered to handle high-volume service while maintaining consistent temperature and fresh taste.

The FCD-4 utilizes Bunn's well-known brewing technology. It is designed with an innovative brew sequence that optimizes coffee extraction, ensuring rich flavor profiles and maximum aroma retention. This technology, coupled with its ability to brew directly into multiple containers, provides operators with versatility and efficiency in serving coffee.

Another characteristic of the FCD-4 is its easy-to-read digital display that shows the current status of the coffee dispenser, including brew levels and operational readiness. This feature enables staff to monitor the workflow seamlessly, reducing wait times for customers.

The Bunn FCD-4 also stands out because of its user-friendly design. It includes ergonomic controls for straightforward operation, making it accessible to users with varying degrees of experience. Moreover, it is equipped with a self-cleaning function that simplifies maintenance, ensuring that the dispenser remains hygienic and operational with minimal downtime.

Durability is a hallmark of Bunn products, and the FCD-4 is no exception. Constructed with high-quality stainless steel, it is built to withstand the rigors of daily use in high-demand environments. The design also includes safety features such as automatic shut-off and temperature controls to prevent overheating, enhancing user safety.

In summary, the Bunn FCD-4 is a versatile and robust coffee dispenser that caters to the needs of commercial environments. Its capacity to hold multiple coffee flavors, advanced brewing technology, user-friendly controls, and durable construction make it a top choice for businesses aiming to deliver high-quality coffee consistently. Whether serving coffee at a busy café or during a large event, the Bunn FCD-4 is designed to enhance the coffee-serving experience.
Top Page Image Contents