Extron electronic RGB 201 Rxi manual Installation and Operation, cont’d Mounting the Interface

Page 18

Installation and Operation, cont’d

Mounting the Interface

The interface can be mounted on tabletops, under desks, through desks, or on racks, as described in this section.

Tabletop placement

For tabletop or desktop placement only, install the self-adhesive rubber feet/pads (provided) onto the four corners of the bottom of the interface enclosure.

Under-desk mounting

1. Secure the optional under-desk mounting brackets (part #70-077-01) to the interface with the six machine screws provided in the mounting kit (figure 2-3).

LEVEL

 

 

 

PEAK

 

BOOST

 

CENTERING

 

CONTROL

 

 

R

 

 

GB

 

 

20

1Rxi

 

 

WITH

 

 

 

 

ADSPTM

Figure 2-3Under-desk mounting

2. Hold the interface with attached brackets against the underside of the desk or other furniture. Mark the location of holes for screws on the desk.

3. Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or desk at the marked screw locations from the underside/inside (concealed side) of the furniture, where the interface will be located.

2-6 RGB 201 Rxi Universal Interface • Installation and Operation

Image 18
Contents RGB 201 Rxi Universal Video Interface with AudioPrecautions 安全须知 中文 FCC Class a NoticePage Quick Start Guide RGB 201 Rxi RGB 201 Rxi Universal Interface Quick Start GuideRemote control. See Switch PositionConnect an RS-232 device To this connector for For details about SIS Commands and the controlTable of Contents Table of Contents, cont’d One Introductionduction,cont’d About this Manual About the RGB 201 RxiRGB 201 Rxi Universal Interface Introduction Features RGB 201 R xi Universal Interface IntroductionIntroduction, cont’d Two Instaltal lationandandOperation,cont’d Installation Overview RGB 201 Rxi Universal Interface Installation and OperationInternal Configuration RGB 201 Rxi Universal Interface Installation and OperationInstallation and Operation, cont’d Sync polarity jumpersInternal sync DIP switches RsGsBs RGB 201 R xi Universal Interface Installation and OperationVideo clamping jumper Installation and Operation, cont’d Mounting the Interface Tabletop placementUnder-desk mounting Through-desk mounting Through-desk mountingInstallation and Operation, cont’d Rack mounting procedure Rack mountingUL guidelines for rack mounting Rack mounting Rear Panel Connections and Switches Pin HD female connectorAudio output connector Connect an audio Connect the cables to five BNCsDdsp Spare Remote connector pinout Front panel controls and indicators Centering controls Many projectors store centering information in their ownLCD screen backlight Centering memoryLCD display Scan rate indicationTroubleshooting If the image does not appear or there is no soundIf the image is not displayed correctly If the interface does not respond to controls If the image is not correctly centeredThree Simple Instruction Set Control RGB 201 Rxi Universal Interface Remote ControlRemoteControl,cont’d Host-to-interface communicationsUsing the command/response table Error responsesTimeout Symbol definitionsCommand/response table for SIS commands RemoteRGB 201 R xi Universal Interface Remote Control Installing the softwareUsing the software Control Software for WindowsRemote Control, cont’d Using the help systemAAppendix Video input ReferencerenceInformation,cont’d SpecificationsVideo Video outputAudio output AudioAudio input Control/remote interfaceGeneral Reference Information, cont’dIncluded Parts Included Parts Part numberCables Optional AccessoriesAccessories Part number Adapter cables with Audio Part numberBNC cables Part number Extron’s Warranty USA, Canada, South America Japan Central AmericaExtron Electronics. All rights reserved