Extron electronic Quick Start Guide RGB 201 Rxi, cont’d, Switch Position, Remote control. See

Quick Start Guide — RGB 201 Rxi, cont’d

R	G	B	R	G	B	R	G	B
H	V	S	H	V	S	H	V	S
RGBHV			RGBS			RGsB
						RsGsBs

Step 8

Audio output — Connect an audio device, such as powered speakers, to this 3.5 mm, 5-pole captive screw connector for balanced or unbalanced audio output. The figure below shows how to wire the captive screw audio connector.

Do not tin the wires!

Tip	L	Tip
Ring		Sleeve
Sleeves		Tip
Tip	R
Ring		Sleeve

Balanced Audio Unbalanced Audio

L R

CConnect the sleeve(s) to ground (). Connecting the sleeve(s) to a negative (-) terminal will damage audio output circuits.

Step 9

DIP switches — Configure the rear panel DIP switches as shown:

Switch		Position	Switch		Position
1	Up	DDSP, no sync processing	5	Up	Mono on left channel
	Down	ADSP		Down	Stereo audio
2	Up	RGsB or RsGsBs output	6	Up	LCD backlight off
	Down	RGBHV or RGBS output		Down	LCD backlight on
3	Up	Serration pulses	7	Up	ID bits 4 & 11 grounded
	Down	No Serration pulses		Down	ID bits unterminated
4	Up	Narrow V sync pulse	8		Spare
	Down	Wide V sync pulse

Step 10	5	1
Remote connector —
Connect an RS-232 device	9	6
to this connector for	Female
	1	5
remote control. See
chapter 3, Remote Control
for details about SIS	6	9
commands and the control		Male

software that is included with the interface.

Pin	RS-232	Function
1	—	—

2TX Transmit data (-)

3RX Receive data (+)

4	—	—
5	Gnd	Signal ground
6	—	—
7	—	—
8	—	—
9	—	—

RGB 201 Rxi Universal Interface • Quick Start Guide