Bunn CEZF, CDBC service manual Dispense Valve

Page 27

SERVICE (cont.)

DISPENSE VALVE

P1919

FIG. 9 DISPENSE VALVE

Location:

The dispense valve is located inside the top cover behind the front end cap.

Test Procedures:

1.Disconnect the brewer from the power source.

2.Check the water level in the tank to confirm that it is within 1/2" from the top of the tank.

3.Connect the brewer to the power source. If the brewer has been set for brewer temperature lock- out, this feature must be disabled. See Page 8 for procedure.

4.Check the dispense valve for coil action. Place the ON/OFF switch in the "ON" position, press and release the BREW switch. Listen carefully in the vicinity of the dispense valve for a "clicking" sound as the coil magnet attracts and repels the plunger.

5.Disconnect the brewer from the power source.

If the sound is heard as described, there may be a blockage in the dispense valve or the water line to the sprayhead. Remove the dispense valve and inspect for wear, and remove waterborne particles.

If the sound is not heard as described, proceed to #6.

6.Connect the voltmeter lead ends to the dispense valve coil terminals. Connect the brewer to the power source. Brewer temperature lockout must be disabled. Place "ON/OFF" Switch in the "ON" position. Press and release the brew switch. The indication must be 120 volts ac for two-wire 120 volt models and three-wire 120/208 volt models.

7.Disconnect the brewer from the power source.

If voltage is present as described, but no coil action is observed, nor "clicking" heard, dispense valve is de- fective. Replace valve and test again to verify repair. If voltage is not present as described, refer to Wiring Diagrams and check the brewer wiring harness. Also check the control board for proper operation. See Pages 22 and 23.

Removal and Replacement:

1.Disconnect wires from the dispense valve.

2.Drain enough water from the tank so the dispense valve is above the water level.

3.Remove water lines from the dispense valve.

4.Remove the two #8-32 nuts securing the dispense valve to the sprayhead panel.

5.Install a new dispense valve using the two #8-32 nuts.

6.Reconnect water lines to the dispense valve and secure in place with clamps.

7.Refer to FIG. 10 when reconnecting wires.

WHI/GRN from

Control Board

WHI from Terminal

Block

P1853

FIG. 10 DISPENSE VALVE WIRING

Page 27

29253 091603

 

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Phone 217 FAX 217 Post Office BOX SPRINGFIELD, IllinoisIntroduction ContentsUser Notices Electrical Requirements Plumbing RequirementsElectrical Hook-Up Operating Controls ON/OFF SwitchBrew Switch Ready IndicatorCleaning Initial SET-UPCoffee Brewing Adjusting Brew Volumes CEZ-APS/TS/TSR Adjustments & Optional SettingsSetting Brew Lockout CDBC-APS/TC/TS/TSR Adjustments & Optional SettingsSetting Brew Temperature Displaying Brew TemperatureCDBC-APS/TC/TS/TSR Adjustments & Optional Settings Water Sensing Threshold Adjustment ProcedureBefore troubleshooting this brewer, check for the following TroubleshootingRemedy TroubleshootingRefill Circuit Problem Probable Cause2a. Water Level Probe Sensing System CDBC-APS/TS/TSR Troubleshooting Refill CircuitHeating Circuit Problem Probable Cause Remedy Water does not heat to proper temperatureWater not touching temperature probe Problem Probable Cause Remedy Troubleshooting Heating CircuitPages 21 ContControl Board Cdbc & CEZ Replace the control board.SeeBrewing Circuit Problem Probable Cause Troubleshooting Brewing Circuit Required Water temperatureSet-upinstructions Dripping from sprayhead Lime build upProblem Probable Cause Dry coffee grounds remain Sprayhead FunnelFunnel loading Cause Things to Check DiagnosticsService Component AccessContents Control Board ServiceControl Board Service Control Board Model CEZ-APS/TS/TSRSwitch Panel Service Switch Panel Model CDBC-APS/TC/TS/TSRON/OFF Switch Wiring Brew Switch Wiring Service Brew Switch Start Model CEZ-APS/TS/TSRDispense Valve Dispense ValveLimit Thermostat Limit ThermostatTank Heater Tank HeaterTank Heater Wiring Service Tank HeaterCheck for continuity across the refill valve coil terminals Refill ValveLevelsingle Phase 120V AC 2 Wire 120/208V AC 3 Wire 120/240V AC 3 WireSchematic Wiring Diagram CEZ-APS/TS/TSR Cdbc 15, 20 & 35 APS/TC/TS 120V AC 2 Wire

CEZF, CDBC specifications

The Bunn CEZF and CDBC are two popular commercial coffee brewers offered by Bunn, a leader in the coffee equipment industry. Both models are designed to meet the demands of high-traffic settings such as cafes, restaurants, and other foodservice establishments. They combine advanced technology with user-friendly features to ensure consistent, high-quality coffee with minimal effort.

The Bunn CEZF model is known for its easy-to-use design and efficiency. One of its standout features is the "Digital Brewer" control, which allows operators to adjust brewing parameters such as brew time and water temperature. This level of customization enables baristas to consistently create the perfect cup of coffee tailored to their specific blends. Furthermore, the CEZF has a unique "intelligent" warming plate that maintains the optimal serving temperature without over-extraction, ensuring that each cup of coffee remains flavorful.

On the other hand, the Bunn CDBC incorporates a dual brewing capacity that allows for larger batches of coffee to be made simultaneously. This feature is particularly beneficial in high-demand environments where quick service is essential. The CDBC also utilizes a patented brew control technology, enabling users to select their brew strength with just a few button presses. This flexibility is complemented by its high-performance heating element, which heats water rapidly, ensuring that coffee is brewed at the ideal temperature for optimal extraction.

Both models are equipped with a large water reservoir, ensuring a continuous supply of hot water for brewing. They also feature high-quality stainless steel constructions that enhance durability and make cleaning easier. The intuitive interface on both models simplifies operation, with clear instructions that allow even novice users to brew exceptional coffee right away.

In terms of safety, both the CEZF and CDBC are designed with auto shut-off features and integrated safety protocols, minimizing the risk of overheating and ensuring a secure brewing environment.

Overall, the Bunn CEZF and CDBC are excellent choices for any commercial kitchen or café looking to serve high-quality coffee efficiently. Their advanced features, durability, and ease of use make them top contenders in the commercial brewing category.
Top Page Image Contents