Bunn CEZF, CDBC Refill Valve, Check for continuity across the refill valve coil terminals

Page 31

SERVICE (cont.)

REFILL VALVE

J3

J4

J6

P1915

FIG. 15 REFILL VALVE

Location:

The refill valve is located inside the trunk on the lower center part of the component bracket.

Test Procedures:

1.Disconnect the brewer from the power source.

2.Disconnect the white and white/blue wires from the refill valve. Set the "ON/OFF" switch in the "ON" upper position.

3.With a voltmeter, check the voltage across the coil wires. Connect the brewer to the power source. The indication must be 120 volts ac for two wire 120 volt models and three wire 120/240 volt models.

4.Disconnect the brewer from the power source.

If voltage is present as described, proceed to #5.

If voltage is not present as described, refer to Wiring Diagrams and check brewer wiring harness.

5.Check for continuity across the refill valve coil terminals.

If continuity is present as described, reconnect the white and white/blue wires from the circuit board.

If continuity is not present as described, replace the refill valve.

6.Check the refill valve for coil action. Connect the brewer to the power source. With "ON/OFF" switch in the "ON' upper position press start switch and listen carefully in the vicinity of the refill valve for a" clicking" sound as the coil magnet attracts.

7.Disconnect the brewer from the power source.

If the sound is heard as described and water will not pass through the refill valve, there may be a blockage in the water line before the refill valve or, the solenoid valve may require inspection for wear, and removal of waterborne particles.

If the sound is not heard as described, replace the refill valve.

Removal and Replacement:

1.Remove both wires from the refill valve.

2.Turn off the water supply to the brewer.

3.Disconnect the water lines to and from the refill valve.

4.Remove the two 1/4"-20 screws securing the refill valve mounting bracket to the component bracket. Remove bracket and valve as an assembly.

5.Using two 1/4"-20 screws install the new refill valve and bracket to the component bracket.

6.Securely fasten the water lines to and from the valve.

7.Refer to FIG. 16 when reconnecting the wires.

WHI from Terminal

Block

WHI/BLU from

Control Board

P1858

FIG. 16 REFILL VALVE WIRING

Page 31

29253 091603

 

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Phone 217 FAX 217 Post Office BOX SPRINGFIELD, IllinoisIntroduction ContentsUser Notices Plumbing Requirements Electrical RequirementsElectrical Hook-Up Operating Controls ON/OFF SwitchBrew Switch Ready IndicatorInitial SET-UP CleaningCoffee Brewing Adjusting Brew Volumes CEZ-APS/TS/TSR Adjustments & Optional SettingsSetting Brew Lockout CDBC-APS/TC/TS/TSR Adjustments & Optional SettingsSetting Brew Temperature Displaying Brew TemperatureCDBC-APS/TC/TS/TSR Adjustments & Optional Settings Water Sensing Threshold Adjustment ProcedureBefore troubleshooting this brewer, check for the following TroubleshootingRemedy TroubleshootingRefill Circuit Problem Probable Cause2a. Water Level Probe Sensing System CDBC-APS/TS/TSR Troubleshooting Refill CircuitWater does not heat to proper temperature Heating Circuit Problem Probable Cause RemedyWater not touching temperature probe Problem Probable Cause Remedy Troubleshooting Heating CircuitPages 21 ContControl Board Cdbc & CEZ Replace the control board.SeeBrewing Circuit Problem Probable Cause Troubleshooting Brewing Circuit Required Water temperatureSet-upinstructions Dripping from sprayhead Lime build upDry coffee grounds remain Sprayhead Funnel Problem Probable CauseFunnel loading Cause Things to Check DiagnosticsComponent Access ServiceContents Control Board ServiceControl Board Service Control Board Model CEZ-APS/TS/TSRSwitch Panel Service Switch Panel Model CDBC-APS/TC/TS/TSRON/OFF Switch Wiring Brew Switch Wiring Service Brew Switch Start Model CEZ-APS/TS/TSRDispense Valve Dispense ValveLimit Thermostat Limit ThermostatTank Heater Tank HeaterTank Heater Wiring Service Tank HeaterCheck for continuity across the refill valve coil terminals Refill ValveLevelsingle Phase 120V AC 2 Wire 120/208V AC 3 Wire 120/240V AC 3 WireSchematic Wiring Diagram CEZ-APS/TS/TSR Cdbc 15, 20 & 35 APS/TC/TS 120V AC 2 Wire

CEZF, CDBC specifications

The Bunn CEZF and CDBC are two popular commercial coffee brewers offered by Bunn, a leader in the coffee equipment industry. Both models are designed to meet the demands of high-traffic settings such as cafes, restaurants, and other foodservice establishments. They combine advanced technology with user-friendly features to ensure consistent, high-quality coffee with minimal effort.

The Bunn CEZF model is known for its easy-to-use design and efficiency. One of its standout features is the "Digital Brewer" control, which allows operators to adjust brewing parameters such as brew time and water temperature. This level of customization enables baristas to consistently create the perfect cup of coffee tailored to their specific blends. Furthermore, the CEZF has a unique "intelligent" warming plate that maintains the optimal serving temperature without over-extraction, ensuring that each cup of coffee remains flavorful.

On the other hand, the Bunn CDBC incorporates a dual brewing capacity that allows for larger batches of coffee to be made simultaneously. This feature is particularly beneficial in high-demand environments where quick service is essential. The CDBC also utilizes a patented brew control technology, enabling users to select their brew strength with just a few button presses. This flexibility is complemented by its high-performance heating element, which heats water rapidly, ensuring that coffee is brewed at the ideal temperature for optimal extraction.

Both models are equipped with a large water reservoir, ensuring a continuous supply of hot water for brewing. They also feature high-quality stainless steel constructions that enhance durability and make cleaning easier. The intuitive interface on both models simplifies operation, with clear instructions that allow even novice users to brew exceptional coffee right away.

In terms of safety, both the CEZF and CDBC are designed with auto shut-off features and integrated safety protocols, minimizing the risk of overheating and ensuring a secure brewing environment.

Overall, the Bunn CEZF and CDBC are excellent choices for any commercial kitchen or café looking to serve high-quality coffee efficiently. Their advanced features, durability, and ease of use make them top contenders in the commercial brewing category.
Top Page Image Contents