Extron electronic DVS 204 D 12V Mounting the Scaler, Tabletop/desktop placement, Rack mounting

Installation and Operation

Mounting the Scaler

Tabletop/desktop placement

For tabletop or desktop placement only, install the self-adhesive rubber feet/pads (provided) onto the four corners of the bottom of the enclosure.

Rack mounting

1. If feet were installed on the bottom of the DVS 204, remove them.

2. Place the DVS 204 on one half of the 1U (one unit high, one unit wide) rack shelf (part #60-190-01). Align the front of the DVS 204 with the front of the shelf, and align the threaded holes on the bottom of the DVS 204 with the holes in the rack shelf.

3. Attach the DVS to the rack shelf with the two provided 4-40 x 3/16" machine screws. Insert the screws from the underside of the shelf, and securely fasten them into diagonally-opposite corners.

False front panel uses 2 front holes.

1
	2
COMPOSITE	3
	4
	YUV	COL/TNT
	S-V		CENTER
	IDEO
	RGB		MENU
		BRT/C
		ONT	SIZE
			NEXT

ADJ
UST
			IR
DIG	DVS
ITAL V			204
	IDEO
		SCALER

Rack mounting the DVS 204

(2) 4-40 x 3/16" Screws

Use 2 mounting holes on opposite corners.

4. Attach the false front panel (provided with the rack shelf) to the unoccupied side of the rack (as shown above), or install a second half- rack-width device in that side by repeating steps 1–3.

5. Attach the rack shelf to the rack using four 10-32 x ¾" bolts (provided). Insert the bolts through #10 beveled washers, then through the holes in the rack ears and rack, as shown above.

2-2 DVS 204 • Installation and Operation