Extron electronic DVS 204 D 12V, DVS 204 12V Front Panel Features, Input selection buttons

Front Panel Features

The front panel buttons, controls, LCD, and infrared sensor of the DVS 204, as shown below, are found on all models of the DVS 204 scaler series. The LEDs above each input button will light green and the LEDs above/below each picture control button will light amber when the button is pressed.

6 7 12

1	2	3	4	COL/TNT CENTER		MENU			ADJUST
									IR
			BRT/CONT		SIZE	NEXT			DVS 204
									DIGITAL VIDEO SCALER
1	2	3	4	5		8	9	10	11

DVS 204 front panel

Input selection buttons

1Composite input button — This button selects composite video input (Input 1).

2Composite/YC/component input button — This button selects composite video, YC, or component video input (Input 2).

3

4

S-video input button — This button selects the S-video input (Input 3).

RGB pass-through/RGBS/RGBcvS input button — This button selects the RGB pass-through (RGBHV, RGBS, RGsB), RGBS (15 kHz), or RGBcvS input (Input 4).

An SDI input signal can be assigned to any of the inputs (Inputs 1 through 4).

Picture adjustment buttons

Pressing these buttons successively will toggle between the different picture adjustment functions and light the LEDs above and below each button.

These buttons have no effect on the RGB pass-through inputs (Input 4).

5Color/Tint control button (Col/Tnt) — This button controls the color and tint adjustment on the display by using the Adjust horizontal and Adjust vertical adjustment knobs. The adjustment range of both color and tint is 0 to 255. See the “Image Adjustments” section in this chapter.

The tint control is not available if the input is component video.

Brightness/Contrast control button (Brt/Cont) — This button controls the brightness and contrast adjustment on the display by using the Adjust horizontal and Adjust vertical adjustment knobs. The adjustment range of both brightness and tint is 0 to 255. See the “Image Adjustments” section in this chapter.

6Center control button — This button controls the centering adjustment on the output display by using the Adjust horizontal and Adjust vertical adjustment knobs. The adjustment range of both horizontal and vertical centering is 0 to +255. See the “Image Adjustments” section in this chapter.

DVS 204 • Installation and Operation 2-7