CDA WF250SS manual Installation dimensions, Building in your appliance under a worktop

2 / INSTALLING YOUR DISHWASHER

•FREE-STANDING APPLIANCES

You can use the top of the appliance as a worktop.

NB:

Do not position your dishwasher too close to a heat source; otherwise the trim around the top could be damaged.

•BUILT-IN APPLIANCES

•Installation dimensions

By removing the appliance’s worktop you can build in your appliance under an existing worktop provided that the space conforms to the dimensions on the sketch. (Fig. 01)

600
570	min
820 min
	mn	570	830
	110		820 -
		50
			595
Fig. 01

•Building in your appliance under a worktop

If you are building in your appliance under an existing worktop:

—Remove the top of the appliance by unscre- wing the two screws under the edge of the top (Fig. 02).

—Remove the top by unclipping it from the back of the appliance and pushing it a few cm to move it (Fig. 03).

—Lift the top of your dishwasher to release it (Fig. 03).

—Insert the dishwasher into its appropriate space

—Adjust the height of the feet, if necessary (please refer to the Section: “Levelling by adjusting the feet”).

—Fasten your dishwasher to the kitchen work- top with two screws under the front of the plastic lip (Fig 04).

If your worktop is marble or a similar material, you can fasten your dishwasher at the side with two brackets (available from After-Sales or your dealer).

You can also incorporate your appliance into a vertical unit (raised above the ground).

Fig. 02

Fig. 03

Fig. 04

Screw

5