5/ DETERGENT PRODUCTS AND ADJUSTING THE WATER SOFTENER
•FOR TRADITIONAL PRODUCTS
•Your machine must be specially adjusted to use traditional products.
•To adjust the water softener using the control panel:
Turn the selector switch to “Select”. The six indicators’ lights come on, meaning you are in adjustment mode.
-Press the “Delay Timer” button once. The setting is indicated by the indicators’ lights flashing on and off (factory setting: 40 to 55°F).
-To change this setting (depending on the hardness of the water), press the “Delay Timer” button repeatedly. Each time you press it, the setting changes.
Please refer to the table below.
-Reset the switch to the Programme or STOP position.
9h |
| Delay |
| ||
6h |
| |
| Timer | |
3h |
| |
|
|
Bio 50° STOP | Eco 55° |
| |
Rapid | Normal 60° |
| |
30' |
| ||
|
| ||
Soak | Intensive 65° | Rinse Aid | |
Salt | |||
|
|
Select
| Test strip |
|
|
|
|
|
|
| Hardness |
|
|
|
|
| > 70°F |
|
| 9h | 9h | 9h | 9h | 9h | 9h |
|
| 6h | 6h | 6h | 6h | 6h | 6h |
Adjust | Traditional | 3h | 3h | 3h | 3h | 3h | 3h |
product |
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
| Rinse Aid | Rinse Aid | Rinse Aid | Rinse Aid | Rinse Aid | Rinse Aid |
|
| Salt | Salt | Salt | Salt | Salt | Salt |
Important: | : indicator light off | : indicator light on | indicator flashing | ||||
|
|
|
|
|
|
It is very important to set the water softener correctly.
-If the setting is too low, there is the risk of chalky marks appearing.
-if the setting is too high, there is the risk of causing clouding of glasses.
If you relocate, adjust the water softener setting as required.
• Traditional tablets
• Powders or liquids (Fig 03)
Fill at least up to the minimum mark for slightly dirty crockery and to the maximum mark for dirty crockery. If the crockery is very dirty and for programmes with a
Important:
Keep these products out of children’s reach and away from dampness. Only use products specially designed for dishwashers.
Fig. 03
Fig. 04
Fig. 05
18