Setting up the Refrigerator/Freezer Combo

Setting up the Refrigerator/Freezer Combo

Be sure to choose a flat and level setup location. Door adjustment

Use sturdy and fireproof supports to correct an

If the freezer compartment door is lower than

unevenness in the floor. Turning an appliance

that of the refrigerator compartment, insert the

foot clockwise raises the appliance, turning it

wrench in the groove of the left screw and turn it

anticlockwise lowers the appliance.

in the direction of the arrow until both doors are

the same height.

Height difference

Height

difference

	Wrench	Left screw
	If the freezer compartment door is lower than
Protect the setup location against direct sunlight	that of the refrigerator compartment, insert the
or heat sources.	wrench in the groove of the left screw and turn it
	in the direction of the arrow until both doors are
	the same height.
		Height difference
	Height difference
		Wrench
		Right bolt

Avoid a damp setup location. Remove water	Be sure to leave at least 10 cm of space around
and dirt with a soft rag.	the appliance. When installing the appliance in
	an enclosed area, leave at least 25 cm of space
	on the sides and 5 cm on the top and back.
	Spacing

Dispenser operation

Choose crushed ice, refrigerated water or ice cubes. Slightly push a glass against the ice/water lever as shown in the illustration.

(1) Dispensing crushed ice

Press the appropriate button so that the indicator for crushed ice lights up.

Lightly press against the lever so that crushed ice is supplied.

(2) Dispensing ice cubes

Press the appropriate button so that the indicator for ice cubes lights up.

Lightly press against the lever so that ice cubes are supplied.

(3) Dispensing refrigerated water

Press the appropriate button so that the indicator for refrigerated water lights up. Lightly press against the lever so that refrigerated water is supplied.

Dispensing crushed ice

Even with the ice cube option selected, some crushed ice may be supplied simultaneously. It is also possible that the crushed ice supply is mingled with a few ice cubes.

When crushed ice is frequently called for, it is normal for frost to build up around the outlet, but it will eventually evaporate.

Keep the glass close to the dispenser to prevent ice from spilling.

Dispensing refrigerated water

Due to air in the water supply line, refrigerated water may not be available immediately after installation. In this case, hold the dispenser lever pressed in for as long as two minutes to evacuate any remaining air.

After that, the supplied water will become increasingly cooler.

Refrigerated water does not contain any ice cubes. To lower the temperature of the refrigerated water, add crushed ice or ice cubes to it.

Caution: Keep fingers and objects away from the dispenser.