Haier WQP4-1A Power failure, ice up or water failure, Ice up, Water failure, No action, At all

Page 15

TROUBLESHOOTING AND MAINTENANCE SERVICE

Power failure, ice up or water failure

Power failure

* Turn off the power switch. Operate it when power resumes.

 

 

 

* Fill warm water (below 31-70°C)to melt the ice.

Ice up

If the hot water pipe and the draining hose are frozen, melt them with warm water.

 

After ice melts, select "prewash"program to make an operation to make sure it is OK.

 

 

 

* If water fails during operation. Cut off the power to stop operation.

Water failure

When water comes again, restart the machine.

Select "prewash"program to drain out dirty water.

 

 

Then begin to wash.

 

 

Under following situation

1)Shut off the power, make a check and take measures as described in the follows:

2)Make a test run after faults have been eliminated.

3)When the above phenomena appear again, take off the plug and contact one of the maintenance departments.

Disorder

Possible causes

Measures to be taken

 

 

 

 

* Power failure.

* Take actions according to the above-mentioned

 

measures incase power failure.

No action

* The fuse in the inhouse switch box is burned.

* Change fuse.

at all

* The power plug is not inserted firmly.

* Insert the plug completely.

 

* The power switch is at "off" position.

 

* Set the switch at"on"position.

 

* The lock is at "open" position.

 

* Set the lock at "close"position.

 

* Program selecting button are not pressed.

 

* Press to confirm.

 

 

Abnormal

* The dishwasher is tilted.

* Level the unit.

sounds

* Chopsticks might block the sprayer.

* Rearrange them.

 

* The sound of spraying water striking the washing box is not

 

 

abnormal.

 

 

 

 

Water leaks

* Foreign substance is jammed between the door and the wa-

* Remove it and adjust it.

at the door

shing box.

 

 

 

 

 

* The draining hose is sunk.

 

No water is

* Ice up.

* Make it to normal condition.

* The middle part or the end of the draining hose is protruded

* Do as mentioned above for "ice up".

drained out.

too high.

 

 

 

 

* It is not abnormal that little water remains in the washing

* The protruding partsshould be less than 10cm.

 

box after operation.

 

GB

KNQK

Image 15
Contents Domestic Dishwasher WQP4-1A Sliding nylon rack FeaturesAutomatic fault alarm Flash washDishwasher Parts and FunctionsWashing indicater On/Off switchDrying indicator Control panelSafety SafetyIt shows items. The contents are as the follows Power cable must not be damaged Do not use the unit as flush dishwasherBe careful with the dishes after washing about 70C Draining hose should be as lateral as possible Cut off the power supply before cleaning or checkingTake off the power plug to prevent thunder Take off the plug ForbiddenBefore Operation Program selection Operation InstructionsSpecial detergent ShelfThe container which dishes are put Is called shelfPut in detergent ShelfPoorer cleanness Dish washingFollows are not abnormal Weekly Maintenance MaintenanceDaily Maintenance Clean the sprayerMonthly Maintenance Appearance cleaning Cleaning the door and washing boxTroubleshooting and Maintenance Service Under following situation Power failure, ice up or water failureIce up Water failureStop operation for a long period Stop Operation for a Long PeriodTechnical Specifications and Packing List Illustration of Dishes Arrangement Quantity of dishes Please arrangeDishes as illustrsted