Haier DW9-TFE1 operation manual Installation, Positioning the appliance, Levelling the appliance

Page 5

Installation

en

 

 

Positioning the appliance

Positioning the appliance in the desired location. The back of the appliance should rest against the wall, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation.

Levelling the appliance

Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the dishwasher, making it level. The appliance should not be inclined more than 2˚. If the appliance is level, it will help ensure proper performance.

Cold water connection

 

Connect the water supply hose to a threaded 3/4 (gas) connector,

 

making sure that it is fastened tightly in place (see fig.A).

 

Some models are fitted with an "Aquastop" water supply hose

 

(see fig.B) in which the small filter is already housed in the

 

threaded end.

fig.A

If the water pipes are new or have not been used for an extended

 

period of time, let the water run to make sure that the water is

 

clear and free of impurities. If this precaution is not taken, there

 

is a risk that the water inlet can get blocked and damage the

 

appliance.

 

Warning

fig.B

The appliance is to be connected to the

 

water mains using new hose-sets and

 

that old hose-sets should not be reused.

 

Anti-Flooding protection

The dishwasher is equipped with a system that stops the supply of water in the event of a problem with the water supply hose, or leaks within the unit, in order to prevent damage to your home. If for any reason the box containing the electrical components happens to get damaged, turn off the power supply and remove the plug for the appliance from the socket immediately. In order to guarantee that the anti-flooding feature operates properly, the "A" box with water supply hose must be attached to the water supply tap as shown in fig.B. No other type of connection is acceptable.The water supply hose must not, under any circumstances, be cut, as it con- tains electrical parts which are live. If the length of the hose is not adequate to make a proper connection, the hose must be replaced with one which is long enough. This hose is available upon request from specialised retailers and approved service center.

4

Image 5
Contents DW9-TFE1 Series Index During installation Safety informationAt time of delivery During normal useWhen disposing of old appliances If a fault occursIf your family includes children Always use original Spare PartsPositioning the appliance InstallationLevelling the appliance Cold water connectionElectrical Connection Drain hose connectionDishwasher interior Getting to know your dishwasherClose-up view control panel Adjusting salt consumption How to fill the saltSalt Loading the salt into the containerLoading the rinse aid How to fill rinse aidRinse aid Loading the detergent How to fill the detergent dispenserDetergent What you should not put into the dishwasher Not suitable for the dishwasherOur recommendation Damage to glassware and other dishesPull out the rack to load the dishwasher How to use the lower rackKnife rack How to use the upper rackShelf Wash Programme overviewHeat SoakEN50242 Washing dishes Switching the dishwasher onProgramme selection Earn savingsCancelling or modifying a cycle Switching the dishwasher OFFReset drain function End of programmeHow to keep your dishwasher in shape Clean both spray arms under running water Care and maintenanceOverall condition of appliance FiltersResolving minor problems yourself Trouble ShootingWhen the appliance is switched on With the appliance itselfLid in detergent compartment cannot be closed Lower spray arm rotates with difficultyRemnants of detergent stuck inside dispenser Spray arm is blocked by small items or food remainsWith the dishes,cutlery, etc During washingDishes,cultlery,etc.have not been dried Plastic items are discolouredGlasses have a dull appearance Traces of rust on cutleryWidth 45 cm Depth 60 cm Height 85 cm Capacity Technical dataGeneral information Important informationArtNo.800-0319 RDW459 Disposal Inhaltsverzeichnis Bei der Anlieferung SicherheitshinweisedeBei der lnstallation Im täglichen BetriebBei auftretenden Schäden Bei Kindern im HaushaltBei der Entsorgung Gefährliche SpannungWaagerechte Aufstellung AufstellenAnschluß an die Kaltwasserleitung ÜberlaufschutzAchtung Anschluß des AbwasserschlauchesElektroanschluß Aus der Nähe betrachtet Bedienblende Geschirrspüler kennen lernenAus der Nähe betrachtet Innenraum Ein-Aus Betriebsanzeige Programm-Auswahltaste Taste Ein-AusSalz Wie wird der Salzbehälter gefüllt ?Einfüllen des Salzes in den Entkalkerbehälter Einstellen des SalzverbrauchsKlarspüler Wie wird der Klarspüler gefüllt ?Einfüllen des Klarspülers Der Entkalker wurde werkseitig auf eingestelltReiniger ReinigerEinfüllen des Behälters Füllen Sie den Reiniger für den Spülgang in die Mulde 6einNicht in Ihrem Geschirrspüler reinigen sollten Sie Nicht geeignetes GeschirrEmpfehlung Glas-und GeschirrschädenDer Besteckkorb kann zweigeteilt werden.siehe Abb.E Geschirr einordnenVerwendung des unteren Korbs Messerablage Was gehört in den Oberen KorbEtagere Programmübersichtde GEN 50242 Vergleichsprüfungen mit Klarspülereinstellung Labormesswert nach europäischer Norm ENProgrammauswahl GeschirrspülenSpartipp ProgrammdatenProgrammende Ablauf ResetGerät ausschalten Programm unterbrechenSo halte ich das Gerät in Topform Gesamtzustand der Maschine Wartung und PflegeSiebe SprüharmeKleine Fehler selbst beheben FehlersucheStörungen Beim Einschalten Am GerätReinigerdeckel lässt sich nicht schließen Unterer Sprüharm dreht sich schwerKontrollanzeigen gehen nach dem Spülen nicht aus Reinigerreste kleben nach dem Spülen im DosierbehälterAm Geschirr Beim SpülenGeschirr wird nicht trocken Auf Kunststoffteilen entstehen VerfärbungenGläser bekommen stumpfes Aussehen Tee oder Lippenstiftreste sind nicht vollständig entferntHinweise Technische DatenHinweis zur Entsorgung Maximale Stromstärke 13A Leistung 1950WHinweise für Vergleichsprüfungen nach EN AllgemeinesTemperaturbegrenzer Motor Ablaufpumpe Motor Waschpumpe