Extron electronic MPA 152 PLUS manual Audio Output, MPA 152 Plus Summing Diagram

Page 15
Audio Output

Audio Output

FSpeaker receptacle — This 4-pole, 5 mm screw lock captive screw receptacle is used to connect the amplifier to the speakers.

With an 8 ohm load, the amplifier produces up to 8 watts per channel. With a 4 ohm load, the amplifier produces up to 15 watts per channel.

8Ω / 4Ω

CLASS 2 WIRING

 

OUTPUT

L

R

See the attention (page 5) and note (page 5) for important information about connecting wires to captive screw connectors.

ATTENTION: Do not short the + and – outputs to each other, as this will damage the amplifier.

Captive

Screw

Left RCA

TRS

Captive

Screw

-

 

+

+

 

Stereo

 

+

 

+

 

+

 

+

 

Dual

 

Mono

 

+

-

+

+

 

+

Right

RCA

TRS

Stereo

+

Amp Stage

+

Stereo/Dual Mono Switch

Figure 7. MPA 152 Plus Summing Diagram

Signal flow is as follows:

1.The MPA 152 Plus sums and weights the left unbalanced signals from the TRS and RCA receptacles. This summed, unbalanced signal is then summed with the left balanced signal from the captive screw receptacle.

2.The right channel is handled in the same way.

3. The left and right channels are then sent to the output amplifiers in one of two ways, depending on how the front panel switch is set.

Stereo: The left and right channels are sent to the left and right output amplifers respectively.

Dual Mono: The left and right channels are summed and then the resulting mono is fed to both of the output amplifiers.

The captive screw, RCA, and TRS inputs are buffered.

MPA 152 Plus • Panels and Cabling

9

Image 15
Contents Audio MPA 152 PlusENERGY STAR Qualified Stereo Mini Power Amplifier User GuideSicherheitsanweisungen Deutsch Safety InstructionsSafety Instructions English Instructions de sécurité FrançaisRegulatory Compliance Guide on the Extron website FCC Class B NoticeSpecifications Availability Conventions Used in this GuideNotifications Contents MPA 152 Plus Contents Introduction Important Safety InstructionsImportant Safety Instructions About the MPA 152 Plus MPA 152 Plus FeaturesMPA 152 Plus Features About the MPA 152 PlusMPA 152 Plus Introduction MPA 152 Plus Introduction MPA 152 Plus Rear Panel Features Power ConnectorPanels and Cabling MPA 152 Plus Panels and Cabling Figure 3. Power ConnectorAudio Inputs Remote Control Wiring for remote controlFigure 5. Remote Control Wiring Ground to ground G Vol/Mute to C 10 V to Figure 7. MPA 152 Plus Summing Diagram Audio OutputFront Panel Features and Operation Setup and OperationFront Panel Features and Operation Setting Input LevelSetting Bass and Treble Remote Control OptionsDefeating the Auto Power-downTimer Amplifier Enters Standby Mode Too Early TroubleshootingAmplifier Fails to Exit Standby Mode PromptlyMounting Rack MountingUL Guidelines for Rack Mounting Rack Mounting Procedure Other Mounting OptionsBack of the Rack Mounting Extron Warranty
Related manuals
Manual 2 pages 53.4 Kb