H. Startup
WARNING
1.All parts are
2.If the icemaker is turned off, wait for at least 3 minutes before restarting the icemaker to prevent damage to the compressor.
3.At startup, confirm that all internal and external connections are free of leaks.
1)Open the water supply line
2)Move the control switch to the "OFF" position. See Fig. 5.
3)Remove the front panel, then move the power switch to the "ON" position. Replace the front panel in its correct position, then turn on the power supply.
Note: This unit will not run if the safety switch is not engaged.
4)Move the control switch to the "ICE" position to start the automatic icemaking process.
5)Once the unit starts to produce ice, allow it to run for another 30 minutes.
6)Move the control switch to the "DRAIN" position. Allow the water system to drain for
5 minutes.
7)Move the dispense mode switch to the "CONTINUOUS" position, then dispense all of the ice from the storage bin.
Note: Ice dispenses continuously for a maximum of 60 seconds per activation.
8)Remove the front panel, then remove the storage bin cover.
9)Move the control switch to the "ICE" position.
10)Confirm bin control operation: Engage the safety switch on the front frame. See Fig. 5. After the compressor starts, press and hold the actuator paddle located inside the storage bin. WARNING! Keep hands, hair, and loose clothing clear of the agitator inside the storage bin. The icemaker should shut down within 10 seconds.
Storage Bin Cover
Power Switch 
Control Box Cover
Actuator Paddle
Safety Switch
CONTROL | |
| |
ICE |
|
OFF | DISPENSE MODE |
| PORTION |
DRAIN | CONTINUOUS |
|
Fig. 5
16