Shelves and Bins
Stainless Steel Refrigerator
Rearranging the shelves
Shelves in the refrigerator compartment are adjustable.
Refrigerator Compartment
To remove:
1Remove all items from the shelf.
2 Tilt the shelf up at the front.
3Lift the shelf up at the back and bring the shelf out.
2 | 1 |
Some models have wire shelves that can be adjusted in the same manner.
To replace:
1 While tilting the shelf up, insert the top hook
at the back of the shelf in a slot on the track. | 1 |
|
2Lower the front of the shelf until the bottom
of the shelf locks into place. | 2 |
|
Slide-out spillproof shelf
The
To remove:
1Remove all items from shelf.
2Slide the shelf out until it stops.
3Lift the front edge of the shelf until the central tabs are above the front bar.
4Continue pulling the shelf forward until it can be removed.
To replace:
1Place the rear shelf tabs just in front
of the central notches on the shelf frame.
2Slide the shelf in until the central tabs are slightly behind the front bar.
3Lower the shelf into place until it is horizontal and slide the shelf in.
Make sure that the shelf sits flat after reinstallation and doesn’t move freely from side to side.
Make sure you push the shelves all the way in before you close the door.
QuickSpace™ shelf
This shelf splits in half and slides under itself for storage of tall items on the shelf below.
This shelf can be removed and replaced or relocated just like
On some models, this shelf can not be used in the lowest position.
12