3M 39600 manual Special Set-Up Procedure, Removing Taping Heads From Case Sealer

Special Set-Up Procedure

WARNING – Turn off electrical power and disconnect power cord from

electrical supply before beginning special set-up procedure. If power cord is not disconnected, severe injury to personnel could result.

Changing Tape Leg Length

(From 70 to 48 mm [2-3/4 to 2 Inches])

The following changes to the case sealer will allow taping boxes 90 mm [3-1/2 inches] minimum height.

CASE SEALER FRAME (Refer to Figure 5-1A)

1.Raise the upper head assembly (by turning crank handle counterclockwise). Remove and retain the two screws and washers from the normal position holes "A-A".

2.Remount and secure the stop bracket in the lower position "A" using the top holes and original fasteners. Relocate both the right and left stop brackets.

TAPING HEADS

WARNINGS

1.Use care when working near tape cut-off knife as knife is extremely sharp. If care is not taken, severe injury to personnel could result.

2.Taping head weighs approximately 7.2 kg [16 lbs]. Use proper body mechanics when lifting upper or lower taping heads.

(Refer to Figures 5-1B and 5-1C)

1.Loosen, but do not remove, the two retaining screws that secure the upper taping head shown in Figure 5-1B.

2.Slide the head forward and lift straight up to remove it from the case sealer.

3.Lift the lower taping head, shown in

Figure 5-1C, straight up to remove it from the case sealer bed.

4.Refer to Section II, Adjustments – Changing Tape Leg Length", page 13 for taping head set-up.

Figure 5-1 – Removing Taping Heads From Case Sealer

25