SECTION 5: PARTS SECTION
Elbow, 1-1/2” 90° Street 04730-206-32-00
Nipple, 1-1/2” NPT 04730-207-40-00
Modified Compression
Fitting
05700-001-16-52
Reducer, 1-1/2” x 1/4” 04730-002-55-76
To Dishmachine Drain
DRAIN QUENCH ASSEMBLY
Drain Quench
Assembly
06401-002-59-52
Lid, Drain Quench
05700-002-67-16
Thermostat 05930-003-13-65
Solenoid Valve 04810-100-09-18
To Cold Water Supply
Tee, 1-1/2” x 1-1/2” x 1-1/2” | | Box, Drain Quench |
04730-011-69-93 | | 05700-002-69-96 |
Reducer, 1-1/2” to 1/2” | Valve, Check, 1/2” | |
04730-002-55-75 | (Not Shown) | Nipple, Close, 1/2” NPT |
| 04820-002-55-77 | (Not Shown) |
| | 04730-207-15-00 |
From the existing drain, attach the two additional Tees using the 1-1/2” NPT Close Nipples. Tighten the Reducers into the Tees as shown above. Attach the Modified Compression Fitting into the 1-1/2” to 1/4” Reducer. Position the bulb of the thermostat so that it rests approximately 1/4” from the bottom of the Tee. Tighten the Modified Compression Fitting as required. Attach to the incoming cold water line. Use pipe dope or thread tape as required to prevent any leaks.
Tempstar LT/NB/S/SDS Technical Manual 7610-011-86-35
Issued: 12-07-2007 Revised: N/A