Miele DA 292 I Fitting the light tube cover, Fitting the cover caps, DA 262, DA 272 i, DA 292

Page 19

Installation

Attach the spacer bar to the guide rail (2) located behind the light tube.

Fitting the light tube cover

– DA 262 i

Pull off the transit strips on each side.

Fitting the cover caps

For cooker hoods without a front panel or lightshield:

Position the light tube cover and screw into place (see diagram).

– DA 272 i, DA 292 i

Attach the extension pieces supplied to the light tube cover, then position the now extended light tube cover and screw into place.

Push the Allen screws from the accessory kit onto the cover caps until the screw heads lie directly under the holes in the cover caps. Secure the cover caps on both sides of the deflector plate using the Allen screws.

Preparing the lightshield

Removing the transit strips

Pull the deflector plate out to its limit.

Lightshields . . .

. . . weighing up to 600 g can be fitted normally.

. . . Those weighing over 600 g need to have the springs in the snap fittings pre- tensioned:

19

Image 19
Contents Operating instructions Cooker hoods DA 262 DA 272 DA 292 DA 262 DA 272 i / DA 292 Description of the applianceAir extraction Slide switch for cooktop illumination nSlide switch for the fan m Slide switch for ,,Power selec- tionContents Disposal of packaging Help to protect our environmentDisposal of your old machine Save These Instructions and Review Them Periodically Page Disposal of discarded appliances After cooking OperationCleaning Cleaning and careGrease filters Inserting or changing the active charcoal filters Changing the light tube and/or starterAfter Sales Service For CDN only Electrical connectionFor USA only Technical data Installation 13/16˝ Appliance dimensions Wall unit dimensionsBuilding Depth alignment DA 262 Fitting the light tube coverFitting the cover caps Preparing the lightshield Removing the transit stripsOnly use the template for lightshields Dismantling Fitting the front facia panel / lightshieldConnection for extraction Air extractionConnection Bend Calculation of extraction ductingAir recirculation Page Page